NEED HELP!!! --- Interior fuse box removal

[rcon07]

Hey guys, i just bought a '96 240sx. When i got it, it was a wreck... So needless to say i have been doing a lot of work on it recently. One of the problems it had when i bought it was that the taillights weren't working. I didnt think anything of it, assuming it was a fuse/ground/etc... I assumed it was something simple. And you know what assuming does, makes a ass out of you and me :nono: So i went to check the fuse and I was right it was the fuse, except for the fact that, the guy that owned it before me totally mangled the slot where the tailight fuse goes in. So basically i need to replace the whole fuse box, right? If so, how do i go about removing it? I have searched high and low for this info but cant find it anywhere. And im trying to do this as painless as possible. If anyone has any helpful info, it would be greatly appreciated. Thanks.

[rcon07]

anybody? does anyone know how to do this?

[rcon07]

really.... not even a response...?

[roboticnissan]

Youre a non searching noob from florida, youre not gonna get help

[rcon07]

HAHAHA bullshit, like ive said in the original post, i have searched everywhere. and what does my location have to do with anything. instead of being a dick how about you just say "hey man, im a spoiled little bitch from I cant make up my mind which part of California, and i dont know shit so i cant help you". That would have been a more honest and ^^^ Helpful answer. Soooo now if anyone can actually help me before i pull the dash out and start just pulling wires to try to figure it out my self, IT WOULD BE GREATLY APPRECIATED. Thanks.

[Memberofthe600hpkaclub]

Easiest way to do it is to just get your hands dirty...gunna be a bitch with the dash in...youll need to pull the driver fender...

[Memberofthe600hpkaclub]

Oh and your best bet is to get an entire new fuse box harness they are not hard to find over here and you don't know what else has been mangled that has been mangled... those sm j's sucks trying to get out of that little ass fender hole

[roboticnissan]

You cant have searched floridian. Theres plenty of interior chassis harness threads.
i also would like to mention how funny your assumption is that im spoiled haha, if you only knew.
and as far as your location of florida, its a scientific fact that here on zilvia, florida members are far more likely to post less than intelligent posts. Here you are proving my point.

[Memberofthe600hpkaclub]

Hey not me :/ lol...but it is sadly true

[rcon07]

thank you Memberofthe600hpkaclub, and roboticnissan the reason my post count is low is because i do search ALOT. Im not saying im a s-chassis genius, but then again who gives a fuck. the whole point of this website is for people to share info with other people and help them out when need be. So guess what??? I asked a question... Wow amazing right?!?! SMH... Its because of people like you that sites like this get a bad rap...

[roboticnissan]

Trust me man. Im the smallest percent contribution to zilvias bad rap haha. Im simply explaining to you why youre getting no help.

[USN_S14]

you could move that fuse to a open slot that isn't being used just means you may have t o extend or cut and re-solder the wire to that fuse slot that's my thoughts on that did that with my infinity M30 when the dash lights fuse slot got corroded and unusable and you cant find the F31's anywhere really they are rare lol so do that if you cant get a interior fuse box