BLITZ LM question

[Pudula]

Right before the throttle body on my Blitz LM intercool kit, the piping has a large hole on it which faces the ground...I originally thought this was to weld a blow off valve flange, but I couldn't understand why they have the Blitz DD blow off vavle kit where the bov is located by the turbo...makes no sense to have both kits with a BOV flange...the hole measure about 1.5 inches in diameter...what is it for??

Thanks, Ryan

[SiDeWaYs S150sx]

hmmmm... that sounds a little off... can u get a pic? My Blitz kit doesn't have any holes near the throttle body, just one right after the hotpipe. Is it threaded or anything??

[wylin]

IIRC and if its what i think your talking about its for the stock bypass valve you will need to plug or weld it shut.

[Kid Zelda]

IIRC and if its what i think your talking about its for the stock bypass valve you will need to plug or weld it shut.

Correct. Its the stock bypass (blow-off) valve

Just plug it, they should have included a cap to use in the DD blow-ff valve kit.
look for it
:)

[Steeles]

or you could recircualte the blitz.

[Pudula]

Shit, no plug included in either kit...gotta rig something now.

[Kid Zelda]

Shit, no plug included in either kit...gotta rig something now.

oic, go to a hardware store, plumbing section, should find something suitable.