Replacing 240sx bushings question!

[xnissan240sx]

My question is on all the arms for my s13, when the bushing is burned out do I remove the metal inserts in all the arms or only specific arms. I have read through all the sites I could find, and some have said don't remove them or its unclear which ones are to be removed. I have the Energy Suspension full bushing kit just to specify which bushings I am trying to put it. http://a8.sphotos.ak.fbcdn.net/hphotos-ak-ash3/538440_10150878168902971_1087195020_n.jpg

[mobr86]

When I did mine the only sleeve that stayed in was the front lower control arm. All the other sleeves I cut and hammered out.

[huffandpuff00]

^^^correct
Read the ES directions...

[xnissan240sx]

alright so I am taking everyone out but the front lower control arm.

[purplove]

The fronts are not necessary to take out. As long as you can squeeze the bushing in there your fine.

[xnissan240sx]

The fronts are not necessary to take out. As long as you can squeeze the bushing in there your fine.

What do you mean by fronts? All the arms in front?

[mobr86]

You leave ONLY the front lower control arm sleeves in. Every other sleeve comes out. If you take the front lower control arm sleeve out then your screwed. You will have a bunch of play in the front end. So take your front lower control arms off then burn the bushings out. Take a wire wheel and clean the inside where the rubber was at. Grease and insert new poly bushings. Done. Move on to everything else and cut the sleeves out. Its super simple but time consuming.

[xnissan240sx]

thank you very much man very help full.