PDA

View Full Version : Fast question!

Srjustin
05-09-2012, 06:43 PM
I got my diff welded on my 240sx. I got it back and can not turn it by hand is this normal? Does it take the power of the car. To turn it? Or did the kid mess my diff up?
NJs13_1993
05-09-2012, 08:26 PM
im pretty sure u should be able to turn it from where the drive shaft attaches by hand
KiLLeR2001
05-09-2012, 09:12 PM
Holy shit Florida derp strikes again.
brizanden
05-09-2012, 09:26 PM
welded output shafts.... LIKE A BAUCEEEEE
Srjustin
05-09-2012, 09:46 PM
Welded out put shaft? That bad? I just wann sure this diff is good, befor i put it in. Ive herd you should be able to turn it by hand. Also ive herd you cant. So plz help i thought this would be simple lol.
brizanden
05-09-2012, 10:04 PM
you should be able to. u only weld the inside parts (spider gears) sounds like he welded the part that still needs to rotate.
slydin240sx
05-09-2012, 10:07 PM
Florida. Well that explains it.

OP your diff is fucked!
Srjustin
05-09-2012, 10:32 PM
Not what i was wanting to here :/. Ok thanx guys. If anyone thinks diffrent let me know.
brizanden
05-09-2012, 10:41 PM
drain it take the cover off and show us what the insides look like then we can give u a definite answer.
justinbyrant
05-23-2012, 11:11 PM
the diff is either fucked or it isnt there is no going back, toss it in and leave it jacked up in the rear (on jackstands of coarse) let the clutch out in first, sometimes you can turn them by hand sometimes you cant, if you cant and he welded it right then its only a matter of time before it goes anyways