ship2236
05-04-2012, 06:06 PM
Story goes like this:
I had a nice built ka-t setup that I got really kind of bored with. Thought id look to change things up so I put it for trade. A member on here (not gonna put names on blast but pm for more details and bewares) contacted me about this motorset he had and was willing to trade straight up for stating all the same reasons as I... Wanting to change it up, bored, yada yada. I was assured the motor was in great working order w a fresh rebuild and headwork, ready to drop in and go... Well we made the exchange, he bit more for some needed parts but i got it squared away, swapped her in, wired this bitch up, started it, ran a compression check and saw the string of lies grow.(i have ALL pm's from this clown for anyone interested)Low compression across the board. The motor dropped a cyl the other day and I just don't have the patience or the will to break this bitch down and rebuild it. Looking to get another ka in good/decent shape. Whoever has the time and want to put into this thing can make it run good with a little effort, new rings and bearings...Been in a few 20's cars and for all that hate on them, when in good shape and minor mods they run hard and take a hell of a beating! Here's what will be included:
~ RB20 unknown mileage (was told around 65k,arp head studs,3 angle valve job hahahahaha who the fuck knows)
~ New Quest 90amp alternator
~ New Z32 thermostat
~ Stock rb20 turbo in great condition
~ Steel braided feed line w AN fittings
~ CX racing tubular bottom mount manifold
~ CX racing same side FMIC w/all piping and couplers
~ Apexi super suction kit
~ Downpipe w new o2 sensor
~ Raw Brokerage silicone radiator hoses
~ Hicas power steering pump an brackets
~ AC compressor
~ 5spd trans in good cond no grinds
~ XTD 6 Puck clutch/stock flywheel and pressure plate
~ mkiney mount kit
~ full harness wired for s13
~ MINES tune Ecu
Also have spare parts that with be included aswell.
RB25 turbo/clutch disk/piping etc...
This is a full turn key kit. It is still in the car and runs on 5cyl for anyone interested in checking it out or doing their own compression check
Looking for a ka setup. Want compression numbers that are real.(no pics from someone else's thread will not be accepted this time around)
Stock KA/ manual trans/ harness/Ecu + $600
Or
KA/ manual trans/ harness/Ecu... with turbo kit complete or not(bottom mount,smic,small turbo preferred)
NOT looking to part!
PM or text
661-400-6774
The swap as a whole is pretty damn clean
Haters need not reply
http://i143.photobucket.com/albums/r134/steveship56/98cd871e.jpg
http://i143.photobucket.com/albums/r134/steveship56/c2b92b37.jpg
http://i143.photobucket.com/albums/r134/steveship56/2e11c4b9.jpg
http://i143.photobucket.com/albums/r134/steveship56/a5da2ab2.jpg
http://i143.photobucket.com/albums/r134/steveship56/4e9996c2.jpg
http://i143.photobucket.com/albums/r134/steveship56/164bc256.jpg
Rb25 turbo/wastegate/elbow
http://i143.photobucket.com/albums/r134/steveship56/092c4107.jpg
http://i143.photobucket.com/albums/r134/steveship56/d26698d4.jpg
I had a nice built ka-t setup that I got really kind of bored with. Thought id look to change things up so I put it for trade. A member on here (not gonna put names on blast but pm for more details and bewares) contacted me about this motorset he had and was willing to trade straight up for stating all the same reasons as I... Wanting to change it up, bored, yada yada. I was assured the motor was in great working order w a fresh rebuild and headwork, ready to drop in and go... Well we made the exchange, he bit more for some needed parts but i got it squared away, swapped her in, wired this bitch up, started it, ran a compression check and saw the string of lies grow.(i have ALL pm's from this clown for anyone interested)Low compression across the board. The motor dropped a cyl the other day and I just don't have the patience or the will to break this bitch down and rebuild it. Looking to get another ka in good/decent shape. Whoever has the time and want to put into this thing can make it run good with a little effort, new rings and bearings...Been in a few 20's cars and for all that hate on them, when in good shape and minor mods they run hard and take a hell of a beating! Here's what will be included:
~ RB20 unknown mileage (was told around 65k,arp head studs,3 angle valve job hahahahaha who the fuck knows)
~ New Quest 90amp alternator
~ New Z32 thermostat
~ Stock rb20 turbo in great condition
~ Steel braided feed line w AN fittings
~ CX racing tubular bottom mount manifold
~ CX racing same side FMIC w/all piping and couplers
~ Apexi super suction kit
~ Downpipe w new o2 sensor
~ Raw Brokerage silicone radiator hoses
~ Hicas power steering pump an brackets
~ AC compressor
~ 5spd trans in good cond no grinds
~ XTD 6 Puck clutch/stock flywheel and pressure plate
~ mkiney mount kit
~ full harness wired for s13
~ MINES tune Ecu
Also have spare parts that with be included aswell.
RB25 turbo/clutch disk/piping etc...
This is a full turn key kit. It is still in the car and runs on 5cyl for anyone interested in checking it out or doing their own compression check
Looking for a ka setup. Want compression numbers that are real.(no pics from someone else's thread will not be accepted this time around)
Stock KA/ manual trans/ harness/Ecu + $600
Or
KA/ manual trans/ harness/Ecu... with turbo kit complete or not(bottom mount,smic,small turbo preferred)
NOT looking to part!
PM or text
661-400-6774
The swap as a whole is pretty damn clean
Haters need not reply
http://i143.photobucket.com/albums/r134/steveship56/98cd871e.jpg
http://i143.photobucket.com/albums/r134/steveship56/c2b92b37.jpg
http://i143.photobucket.com/albums/r134/steveship56/2e11c4b9.jpg
http://i143.photobucket.com/albums/r134/steveship56/a5da2ab2.jpg
http://i143.photobucket.com/albums/r134/steveship56/4e9996c2.jpg
http://i143.photobucket.com/albums/r134/steveship56/164bc256.jpg
Rb25 turbo/wastegate/elbow
http://i143.photobucket.com/albums/r134/steveship56/092c4107.jpg
http://i143.photobucket.com/albums/r134/steveship56/d26698d4.jpg