Freddy Intake manifold questions...

[sr20time]

Hi i just bought a Freddy Intake manifold used from zilvia and i was wondering if there are any parts that i need ontop of this to make this setup work properly... my thoughts were as follow...

Aftermarket FPR? (also do i need an adapter to run an aftermarket FPR?) Will stock FPR work?

And the throttle body... That can be hooked right up? (stock TB)

And what Intercooler Piping Do i need? cause i have the stock setup.. But i can tell its not going to be in the same spot?

thanks... any other suggestions is appreciated...

[EDacIouSX]

you should try searching installation guides for a Greddy intake manifold....

[slider2828]

Search for a thread, there is a write up and review of this and how to install in the tech section

[ultimateirving]

only need a different cold side pipe, TB will mount fine, ADj fpr not required, u might have to cut the fuel rail slightly.