s13 rb20 driveshaft ???

[nv1992]

ok im doing an rb20 swap in my s13. im using mckinney motorsports mounts and im having a problem with my driveshaft. if i put the motor in where its supposed to go the driveshaft is an inch to long. if i put the driveshaft in and push the motor and trans back the oil pan hits my sway bar. i read that i could use my s13 driveshft with my rb20 swap. however i havent found that i can use the stock driveshaft with mckinney mounts ? wasnt sure if there mounts are made for there driveshaft only or what ? ive searched and still cant find the problem. ANY help would be greatly appreciated. THANKS

[Lethal240SX93]

Is it an automatic driveshaft or a manual trans driveshaft? Only manual will fit. I'm currently working on the same swap, with McKinney mounts, but my motor's not in yet. I'll let you know how it goes.

[Yellow4g63]

If your car was a 5speed then the stock drive shaft will work with the RB20 trans.

[chubz7793]

It works you have to really force it in I had my yoke cut to fit

[Yellow4g63]

Or take the dust shield off of the RB transmission if it's still there.

[nv1992]

it was the dust shield on the rb trans that i forgot to remove. fits perfect now. thanks