slipnslide88
04-14-2012, 07:20 PM
i am looking to trade my full VH45de swap for a built SR. when i say built i mean forged internals upgraded turbo tuned. i will also need mounts, tranny intercooler set up etc. the works pretty much because thats what im offering.
ok so heres what i have its a 94 VH45de good year. motor has just barely 100k miles. my previous vh45 had close to 300k and i was on the 7800rpm rev limiter regularly. i have had this one running for a few weeks now. havent been hard on it yet. i got it up around 6500 or so to make sure it pulled strong.
full running set up what it includes
94 VH45de
has the 300ZX twin turbo tranny with a nearly new SPEC stage 2 clutch
Mazworx soldered and depinned wiring harness set up for s14.
has the good 91 ECU tuned by MAzworx
also has the Dakota Digital for the gauges to work speedo and tac.
MAzworx engine and tranny mounts.
MAzwork did all the grinding on the tranny for the mounting plate.
MAzworx power steering lines.
Mazworx light weight driveshaft
Mazworx shifter kit.
Mazworx long tubes.
also have a full exhaust for s14. twin 2.5" piping run through a
Magnaflow muffler. sounds amazing. best sounding VH45 to me.
gaskets all replaced before motor was installed.
this is everything to have a running car if i left out some stuff i drive the car daily.
heres a vid my buddy made its half to 3/4 throttle throuhout. very powerful
http://www.youtube.com/watch?v=6UQTOpPPZ4
i attached some pics of the motor last one is under the intake just to show how clean it all is.
text me at 256 554 0271 im located in northwest al
ok so heres what i have its a 94 VH45de good year. motor has just barely 100k miles. my previous vh45 had close to 300k and i was on the 7800rpm rev limiter regularly. i have had this one running for a few weeks now. havent been hard on it yet. i got it up around 6500 or so to make sure it pulled strong.
full running set up what it includes
94 VH45de
has the 300ZX twin turbo tranny with a nearly new SPEC stage 2 clutch
Mazworx soldered and depinned wiring harness set up for s14.
has the good 91 ECU tuned by MAzworx
also has the Dakota Digital for the gauges to work speedo and tac.
MAzworx engine and tranny mounts.
MAzwork did all the grinding on the tranny for the mounting plate.
MAzworx power steering lines.
Mazworx light weight driveshaft
Mazworx shifter kit.
Mazworx long tubes.
also have a full exhaust for s14. twin 2.5" piping run through a
Magnaflow muffler. sounds amazing. best sounding VH45 to me.
gaskets all replaced before motor was installed.
this is everything to have a running car if i left out some stuff i drive the car daily.
heres a vid my buddy made its half to 3/4 throttle throuhout. very powerful
http://www.youtube.com/watch?v=6UQTOpPPZ4
i attached some pics of the motor last one is under the intake just to show how clean it all is.
text me at 256 554 0271 im located in northwest al