Bee-R please help :(

[CTblack240]

Hey guys, so I tried installing my Bee-R on my RB20. I followed the guide online and wired it this way -

Black to first pin on the ECU
Red to the next pin over from black
Green to the 2nd to last pin on the same block
Yellow to the next pin over from green
White to nothing

Kept the white, brown and grey intact

Car wont start, it will however start without the Bee-R wired in. I also tried to swap the green/yellow a couple times, nothing helped. Am I doing something wrong or is there a certain number I'm supposed to set the Gain and Rev 1 to start the car? I didn't think there was. Is the Bee-R itself broken? Any ideas would be awesome, thanks.

[cotbu]

Confirm that all wires are connected properly, then reconnect battery

Start the car up (Car will not start if Green and yellow wire on ECU are connected wrong way round)

Make sure that both Rev1 adn Rev2 are set to 0 and rev the car and confirm that it limits at 2500rpm

change rev1 and rev 2 settings and confirm that the limit changes when handbrake/switch is engaged.

[CTblack240]

Checked all connections twice, still wont start :/

[cotbu]

List you actual Bee-r color wire to pin number location.

[CTblack240]

Bee-R to pin

Black to #50
Red to #49
Green to #41
Yellow to #42

All 3 wires near the actual unit are connected.

White wire near the 4 other wires at the end, isnt connected to anything.



http://www.skylinesaustralia.com/forums/uploads/post-11389-1175676005.gif

[cotbu]

Have you tried swapping those wires around? That white wire is for the launch control.

Sent from my Highly Tuned Vibrant!!

[slydin240sx]

Did you buy the wrong one? I noticed you were trying to sell one on the book of faces.