MOARLOWR
03-22-2012, 03:29 PM
Selling my 1992 180sx
7500$
Needs a sask safety and alignment, if sold in sask for 7500$ it will be safetied.
bought it, built it, got into school and need money
good compession across the board, runs and drives, needs an alignment, wiht the amount of suspension work done, it would make a killer weekend warrior, all the lights work, dash works.
Tuned ECU for 14psi, stock ecu is in for the time being.
Current parts list
Engine: s14 VVL motor
S15 bb turbo
PBM Rad
PRM highmount intercooler
PBM swirl pot
ISIS dual fans with shroud
Ebay coil cooler with braided lines, -8 an fittings and oil filter relocation.
Magnaflo fuel pressure regulator.
Walburo 255 fuel pump
300zx fuel filter
Z32 maf
Trust intake
isis rad hoses
Driftfreak (zilvia) motor mounts
Unknown Dual dowpipe, with the best fitment I have ever seen, almost touches the floor, and is tucked up above the frame rails.
And ISIS dual 3inch blast pipe
Suspension:
Stance- RUCA, Toe, & Traction arms
PBM subframe risers
Jic magic- inner & outer Tie rods with steering spacer
Jic magic - coils with 10/8 springs
Front and rear strut bars
Brakes:
R33 front and rear Calipers
Project Mu pads
SS Brake lines front and rear
Driveline:
Exedy 3 puck clutch
tomie 11lbs fly wheel
Drive shaft shop one piece steel driveshaft
Peak performance solid tranny mount
ATS 2way differential with 5 bolt axels. Locks like no other
Full five lug swap with APR wheel studs ( stupid 12x1.5 thread pitch)
300zx slave
Interior:
Beat to shit Sparco seat, Used in Mike Pollards car in the 2010 Ebisu drift matsuri (fun fact)
RCI 5 point harnes
Sparco deep dish wheel- 2 spoke
Nismo weighted shift nob/dildo nob
Apexi boost guage
AEM wide band
HKS EVE 3 boost controller
toggle controlled fans
gutted, no heater or AC
Exterior:
Carbon fiber VIS hood, still rather iffy on weather or not I like it. It was free so I cannot lose.
Front no name 20mm over fenders
manrays wheels with mismatch tire pile wheels 17x8 +14, fornt with 10 mill spacers
blue pig nose
Need to sell, got into school, and just dont want a money pit
Best way to get ahold of me, is my cell
1306 2905428
Text for pics if wanted ASAP
Ill post pics in abit.
7500$ obo,
Car is located in Saskatoon SK
Canada
7500$
Needs a sask safety and alignment, if sold in sask for 7500$ it will be safetied.
bought it, built it, got into school and need money
good compession across the board, runs and drives, needs an alignment, wiht the amount of suspension work done, it would make a killer weekend warrior, all the lights work, dash works.
Tuned ECU for 14psi, stock ecu is in for the time being.
Current parts list
Engine: s14 VVL motor
S15 bb turbo
PBM Rad
PRM highmount intercooler
PBM swirl pot
ISIS dual fans with shroud
Ebay coil cooler with braided lines, -8 an fittings and oil filter relocation.
Magnaflo fuel pressure regulator.
Walburo 255 fuel pump
300zx fuel filter
Z32 maf
Trust intake
isis rad hoses
Driftfreak (zilvia) motor mounts
Unknown Dual dowpipe, with the best fitment I have ever seen, almost touches the floor, and is tucked up above the frame rails.
And ISIS dual 3inch blast pipe
Suspension:
Stance- RUCA, Toe, & Traction arms
PBM subframe risers
Jic magic- inner & outer Tie rods with steering spacer
Jic magic - coils with 10/8 springs
Front and rear strut bars
Brakes:
R33 front and rear Calipers
Project Mu pads
SS Brake lines front and rear
Driveline:
Exedy 3 puck clutch
tomie 11lbs fly wheel
Drive shaft shop one piece steel driveshaft
Peak performance solid tranny mount
ATS 2way differential with 5 bolt axels. Locks like no other
Full five lug swap with APR wheel studs ( stupid 12x1.5 thread pitch)
300zx slave
Interior:
Beat to shit Sparco seat, Used in Mike Pollards car in the 2010 Ebisu drift matsuri (fun fact)
RCI 5 point harnes
Sparco deep dish wheel- 2 spoke
Nismo weighted shift nob/dildo nob
Apexi boost guage
AEM wide band
HKS EVE 3 boost controller
toggle controlled fans
gutted, no heater or AC
Exterior:
Carbon fiber VIS hood, still rather iffy on weather or not I like it. It was free so I cannot lose.
Front no name 20mm over fenders
manrays wheels with mismatch tire pile wheels 17x8 +14, fornt with 10 mill spacers
blue pig nose
Need to sell, got into school, and just dont want a money pit
Best way to get ahold of me, is my cell
1306 2905428
Text for pics if wanted ASAP
Ill post pics in abit.
7500$ obo,
Car is located in Saskatoon SK
Canada