Log in

View Full Version : ka24de Idle/run problem


xAJAxY
03-16-2012, 06:40 PM
yes i searched...

s13 91' KA24DE it used to be A/T , now its M/t

okay problem used to be that my car idled at 1600RPM and it would bounce around from time to time. whenever I drove it and engaged the clutch my RPMS would drop and my motor will be near death , or it will just die .

so I did my research and blahblahblah. people saying it could be that my IAVC is clogged up. so i took that bitch off and cleaned it. as well as my throttle body and MAF.

ever since then my car runs WAYY stupid. it has no pull, seems like the engine is flooding with gas or some shit. car idles at 2000RPM
and everytime i engage clutch it dies.
the car sometimes idles low &bounces between 200-400

HELP anybody

Tantwoforty
03-18-2012, 04:38 AM
do you have a check engine light?
if you have a volt meter you can check a few sensors pretty easily
is it smokeing at all?
have you checked the timing?
could it be a vaccume leak?
how are your spark plugs?

idk

xAJAxY
03-19-2012, 07:20 PM
do you have a check engine light?
if you have a volt meter you can check a few sensors pretty easily
is it smokeing at all?
have you checked the timing?
could it be a vaccume leak?
how are your spark plugs?

idk
no smoking

ill check everything asap
ill use this as a checklist
thanks

LuckyRPS13
03-20-2012, 01:41 AM
Check fuel pressure, do you have any fuel injectors leaking or stuck open? Is the engine flooding out? I have seen a MAF flood an engine as well.

If your fuel is all good, check the intake manifold gaskets and vac lines.
If that is good do a compression check.
If that is good go through your ignition system.

xAJAxY
03-21-2012, 12:58 AM
Check fuel pressure, do you have any fuel injectors leaking or stuck open? Is the engine flooding out? I have seen a MAF flood an engine as well.

If your fuel is all good, check the intake manifold gaskets and vac lines.
If that is good do a compression check.
If that is good go through your ignition system.

to be honest i have no tools at the moment.
so i really cant even do anything