rb25det tps

[gsn0526]

need help my tps is shitting out i think. i found this on zilvia it was an older post can anyone help me out with the shaving and rewire part. atleast elaborate on it please


Using a rb25 tps will work.

If you can't get a hold of one use a vh45/vg30/ tps with the corresponding idle switch, it will need small amount of shaving and a re-wire.

finding a RB Tps is a pain in the ass, junkyard to avoid the time finding one.

[Epic Fail14]

Hey sounds like the same problem im having. im running a rb25det s2 and currently installed a 94 q45 tb and im putting out 4.41v to the sensor from yel /blk wire but not getting any signal back from the tps . This is the 3rd tps I've tried the car under load reads 9.1 on the wideband just before it fuel cuts at 4600rpm.Help!!!!!!!

[gsn0526]

ok i didnt get much feedback. but i cleaned out the iacv and it didnt help. then i unplugged the brown plug off of the iacv. and it idled fine. but after reving the motor with it unplugged it seemed like it was bogging enough to just about turn off so i compensated with the idle screw in the side of the whole assembly.

is this okay to do?