Manual boost controller setup

[warauto]

Hello everyone,
Before everyone starts to tell me to search let me explain my problem. I have had an Sr20det for close to 5 years 4 years of which I have run a manual boost controller without problems. Recently I have decided to clean my engine bay up and get rid of my 2 piece hotpipe and replace it with a cxracing single piece unit.


Problem: old pipes had boost pressure line to connect to my manual boost controller to, cxracing line does not.

From what I have read the bottom of the throttle body vaccum lines are boost lines, could I just tap into these or do I need to weld a vacuum fitting on the hotpipe?

I really would like another option rather than welding a boost nipple on that single piece beauty:hide:

[ryandriftingfat]

That thing of beauty is going to get dirty in a hurry. So don't worry about it, boost pressure source should be near the compressor with short lines to your BC.

Get out your drill.

[warauto]

Has anyone used the boost source from under the throttle body, with good results?