View Full Version : S14 5 spd swap Help
S14_DREAMS
02-18-2012, 02:20 PM
Where is the clutch switch harness located?is it tucked somewhere by the clutch pedal?
Arsenal240sx
02-18-2012, 02:50 PM
You should just bypass it. The auto car doesnt have the switch.
S14_DREAMS
02-18-2012, 02:54 PM
How do I bypass the switch?
s14newb
02-18-2012, 03:21 PM
I think the clutch switch is the top connector behind the fuse box. But take that connector plug it in and then take the two wires that come out of the connector and jump them together. Thats what i did to get mine started when i did it a couple months ago.
Heres a good description of the wiring for the swap.
S14 5-speed Transmission Swap - Electrical Connections (http://www.ka24development.com/cwilfert/S14_tranny_swap_electrical.html)
S14_DREAMS
02-18-2012, 03:36 PM
Ok, I have that connected my car turns over but not start.i followed everything that was on that "auto to 5spd" thread from ka24development.i am wondering about the 2nd & 4th plugs where do those other wires go? And do they need to be connected in order for my car to start?
Arsenal240sx
02-18-2012, 06:34 PM
If your car turns over and it wont start It wouldnt be because of the transmission wiring.
S14_DREAMS
02-18-2012, 07:50 PM
My guess is the CAS.
s14newb
02-18-2012, 08:33 PM
Are you getting fuel or spark? Is your pump priming? did you do an engine swap or just five speed swap?
S14_DREAMS
02-18-2012, 10:11 PM
I did a motor and a manual transmission swap.I do not have fuel or spark.
s14newb
02-18-2012, 10:15 PM
Check grounds, check the plug that goes into your ecu, and there is another plug down by the ecu too that has a clip that needs to slide over it. I did an sr swap wasn't getting fuel or spark and it ended up being the other plug by the ecu.
S14_DREAMS
02-18-2012, 10:46 PM
The ECM? What was wrong with yours?
s14newb
02-18-2012, 10:49 PM
Nothing wrong with it. Just make sure the plug on the ecu is tight, as in the bolt on the plug is in tight, and also make sure the other big plug that is down there is plugged in the whole way as well. I didn't have fuel or spark and my problem ended up being that the other plug near the ecu wasn't clipped in the whole way
S14_DREAMS
02-18-2012, 10:53 PM
Ok ill try that
S14_DREAMS
02-19-2012, 06:24 PM
update: That was surely the problem.Thanks everyone for your help.:fruit:
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.