s14 check egine light

[chengy25]

Ok so i need help with my check engine light i tested it with the obd reader and it said that it was the intake air temp sensor but my s14 dosnt have a iat pug so any suggestions please help i need to smog my car

[Edwin562]

is it throwing code 41??

[chengy25]

no its throwing code p0110

[idlafie]

Check your mass air flow sensor. The air intake sensor may be part of the MAF sensor.

OBDII Code P0110 NISSAN - Intake Air Temperature Sensor Signal Range/Performance | Engine-Codes.com (http://engine-codes.com/p0110_nissan.html)

Download a Factory Service Manual here from Zilvia.net. Use the SEARCH function to find it. Follow the troubleshooting procedures in the FSM to figure how how to fix the problem.

Hope this helps....

ID

[nautical miles]

obdII ka's have a an IAT, in its stock location it belongs in the "snorkel" if you will, that goes from the air box to the top of the radiator. if you're looking at the "snorkel" it goes into the right side looking at it (if that makes sense). however, most people's are removed and it leaves the sensor and harness roaming free in the engine bay. the easiest way to figure out where your's is, on the harness that runs across the front of the engine and it splits off to the MAF there should be another wire that branches of. obviously the other one is the iat. it looks like a small probe. fyi, in the factory service manual it says that the sensor is not used to control the engine system it is only used for the on-board diagnosis. Also, scanner code for the IAT is, p0110.... self diagnosis (when you read the flashing lights) is 0401. All of this same information located in pg EC-106 of the 240sx fsm as well as trouble shooting steps. 240sx FSM, Full Service Manuals, S13, S14, KA24E, KA24DE : 240sx General Discussion (http://forums.nicoclub.com/240sx-fsm-full-service-manuals-s13-s14-ka24e-ka24de-t311075.html)