Clutch Pedal

[gue399108]

i just bought a 1993 nissan 240sx and i needed a slave cylinder for it so i bought a new one and put it in and bled it and it works but when i press the pedal down it comes up by itself but towards its way up it stops a little after the clutch engages so i have to use my foot to bring the pedal all the way up. Any ideas on what this might be?

[rcdad123]

need to bleed it some more. get rid of the clutch damper also. it`s the part that is between the slave and the master that is bolted on the floor board.

[gue399108]

Cool thanks. I'm gunna bleed it and remove that damper. I never knew it had one

[andrew600]

i would replace the whole line system with a auto to man clutch line. its works great and gives you great peice of mind. way better than multiple connections that will leak at any given moment.

[s13turbohatch]

Removing that damper is a great idea, also have you tried adjusting where the clutch engages? It probably needs bled more but adjusting the engagement is like a final touch up.

[Tokona-x]

+1 for removing the clutch damper :bigok:

[gue399108]

No i haven't tried to adjust it but im going to bleed it first and then remove the damper and if i feel i need to then ill adjust it. Thanks everyone.

[andrew600]

you will need to bleed it again if you bleed it first then remove the damper.

[s13turbohatch]

Yeah you need to remove it first, and if your car is super low don't just leave it hanging there like i did, i can't reach it and forget to remove it everytime i jack up the car.