Zreddy
01-23-2012, 10:43 PM
Parts list:
-99 Camaro SS Ls1 Engine
-Ls6 "z06" Intake Manifold
-2004 GTO t56 transmission
-Ls7 "new" Clutch and Flywheel
-R1 front strut bar
-Custom headers to Apexi N1 exhaust (has resonator)
-Supra Fuel Pump
-Aeromotive Fuel Pump Regulator
-New Fuel Lines
-"New" Water Pump (will include reciept that has a full warranty, incase of failure, which is fully replaceable)
-Brembo Drilled Rotors
-Hinson Supercar Lsx mounting kit (http://hinsonsupercars.com/s-602-lsx...nting-kit.aspx) can be found there if you dont know what im talking about.
-Torque Arm
-Lsx Driveshaft
-Lsx Subframe
-Transmission Brace
Hinson Supercar
-Power Steering Kit
-Battery Relocation Kit
- VIS Carbon Fiber Hood w/ latches
- Has a perfectly working radio w/ single cd player "car is prewired for a subwoofer, which I can include as well"
- Lowered on Tokico Illumina Shocks with Tein S-tech Springs
- AME Shallen CX 18x9 +0, 18x10 -16
- Brand new tires
- JDM rear tail lights
-R1 Front Lip Spoiler
Pros:
"Clean Title"
"Registered and Smogged"
Runs prefectly fine
Cooling Fans run manually (but temperature was checked at my friends shop, so it doesnt over heat or anything)
Has Power Steering
Tinted Windows
Fuel Cut switch
Rpm Tachometer works
Fuel Gauge work
Cons:
AC is not installed, but I have the AC compressor"just needs to be hooked up"
Speedometer doesnt work (can purchase speedometer correction chip here: http://hinsonsupercars.com/p-398-spe...orrection.aspx)
Temperature Gauge doesnt work, needs to be hooked up (temperature was checked with a professional thermometer, runs perfectly cool)
Oil Temperature Gauge needs to be hooked up
Rear bumper will need some painting or so (previous owner tried doing a custom wide body kit, but never ended up finishing the project)
- You can see from the rear panel of the picture below (its just bondo, and can be sanded down easily)
*Exterior is about 8/10 (paint slightly fading in some places with some small dings and dents)
*Interior is 8.5/10 or even better (missing two inteior panels)
*Passenger door does not open from the outside, needs to be fixed.
*Oil pan had a small crack because the car was too low when I had coilovers, but was rewelded and fixed.
http://i28.photobucket.com/albums/c236/xicema17x/1320980177.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1320980174.jpg
http://i28.photobucket.com/albums/c236/xicema17x/Picture029-1.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1321574764.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1321574765.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1321574768.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1320980204.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1320980166.jpg
New price is $14,000 obo with stock wheels
AME Shallen CX wheels are still available FOR SALE as well for an additional cost
Please again feel free to PM me with any questions or inquires.
-99 Camaro SS Ls1 Engine
-Ls6 "z06" Intake Manifold
-2004 GTO t56 transmission
-Ls7 "new" Clutch and Flywheel
-R1 front strut bar
-Custom headers to Apexi N1 exhaust (has resonator)
-Supra Fuel Pump
-Aeromotive Fuel Pump Regulator
-New Fuel Lines
-"New" Water Pump (will include reciept that has a full warranty, incase of failure, which is fully replaceable)
-Brembo Drilled Rotors
-Hinson Supercar Lsx mounting kit (http://hinsonsupercars.com/s-602-lsx...nting-kit.aspx) can be found there if you dont know what im talking about.
-Torque Arm
-Lsx Driveshaft
-Lsx Subframe
-Transmission Brace
Hinson Supercar
-Power Steering Kit
-Battery Relocation Kit
- VIS Carbon Fiber Hood w/ latches
- Has a perfectly working radio w/ single cd player "car is prewired for a subwoofer, which I can include as well"
- Lowered on Tokico Illumina Shocks with Tein S-tech Springs
- AME Shallen CX 18x9 +0, 18x10 -16
- Brand new tires
- JDM rear tail lights
-R1 Front Lip Spoiler
Pros:
"Clean Title"
"Registered and Smogged"
Runs prefectly fine
Cooling Fans run manually (but temperature was checked at my friends shop, so it doesnt over heat or anything)
Has Power Steering
Tinted Windows
Fuel Cut switch
Rpm Tachometer works
Fuel Gauge work
Cons:
AC is not installed, but I have the AC compressor"just needs to be hooked up"
Speedometer doesnt work (can purchase speedometer correction chip here: http://hinsonsupercars.com/p-398-spe...orrection.aspx)
Temperature Gauge doesnt work, needs to be hooked up (temperature was checked with a professional thermometer, runs perfectly cool)
Oil Temperature Gauge needs to be hooked up
Rear bumper will need some painting or so (previous owner tried doing a custom wide body kit, but never ended up finishing the project)
- You can see from the rear panel of the picture below (its just bondo, and can be sanded down easily)
*Exterior is about 8/10 (paint slightly fading in some places with some small dings and dents)
*Interior is 8.5/10 or even better (missing two inteior panels)
*Passenger door does not open from the outside, needs to be fixed.
*Oil pan had a small crack because the car was too low when I had coilovers, but was rewelded and fixed.
http://i28.photobucket.com/albums/c236/xicema17x/1320980177.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1320980174.jpg
http://i28.photobucket.com/albums/c236/xicema17x/Picture029-1.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1321574764.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1321574765.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1321574768.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1320980204.jpg
http://i28.photobucket.com/albums/c236/xicema17x/1320980166.jpg
New price is $14,000 obo with stock wheels
AME Shallen CX wheels are still available FOR SALE as well for an additional cost
Please again feel free to PM me with any questions or inquires.