cp pistons on stock sr rods?

[lucas240sx]

running it this way should be fine right?
Im only looking to get max 300( doubt ill get there anytime soon)

Also does anyone sell sr transmission gasket and seals as a set or do i have to buy them seperate?

Thx guys

[jr_ss]

Yes, it's been done thousands of times... Don't have an answer for you on the transmission crap.

[UNITEDMASTER]

UGGHHHH .... yea CP's & stock rod work just fine. I would reccomed you get the small end pin fit & matched per rod & piston combo. DONE

[lucas240sx]

Ok thx guys....im sry if this is a repeat....ill have the pin mathed...thx for that info

[idahotuner]

just do it all lol, cause you regret it again

[jr_ss]

just do it all lol, cause you regret it again

I agree and disagree...

I think the stock rods w/ upgraded hardware are fine for anything up to 500hp. Honestly, if I was doing a mild build, not looking for anything crazy, CP's and stock rods with ARP2000's would be the route I took.

However, if you have the funds, you can get some good rods for relatively cheap. And since you're already in there, blah blah blah, you might as well do it.

[lucas240sx]

well im not looking to produce any more than 300
but im tempted to pick up some eagles for 275.....but if my stcok rods will hamdle if i get new hardware.....then ill just go that route