S14 kouki ka into 95 zenki

[Sideways_blksr20]

Sup guys ,im almost done with this swap ,but some plugs from the zenki chassis are different , specially the one from the starter, the zenki its a 2 wire plug and the kouki its a 3 wire plug ,also the windshield wiper plug its different too . is there a way to
Modify this , i searched already .
This is everything i got from the kouki
Motor
Tranny
Harness
Ecu
Lower harness
Thanks .

[silver350z05rb]

The wipers are easy,u just have to find a clip to match your zenki wiper motor, .....one wire is power,one wire is ground,the rest are speed,low, med,high, turn ignition power on,turn wiper motor ON,then put a test light to the wires to see which is power and so on,then just rewire to new zenki clip accordingly.

[Sideways_blksr20]

Thanks what about the ine for the starter ?

[silver350z05rb]

Not sure for the starter,maybe some pics of that clip?

[Sideways_blksr20]

This is the plug from the kouki engine harness
http://i174.photobucket.com/albums/w97/cory_cnx/b5a71694.jpg

http://i174.photobucket.com/albums/w97/cory_cnx/6de4041f.jpg

And this is the one from my chassis harness
http://i174.photobucket.com/albums/w97/cory_cnx/1b126609.jpg

http://i174.photobucket.com/albums/w97/cory_cnx/5db31fa6.jpg

[Sideways_blksr20]

My friend told me to find out about the two skiny wires from the kouki harness,cause the fat one will match the strter signal but i wanna know what r the other 2 wires for .
I downloaded the fsm and cant find shit .

[stunnaben]

LOL I had the same problem. I am about 90% sure those are for the transmission. I can't remember. I had mine jimmy rigged with a jumper for the starter and left the two little ones alone. Car runs fine.

[gunmetalr32]

just get a zenki ka starter..

[Sideways_blksr20]

LOL I had the same problem. I am about 90% sure those are for the transmission. I can't remember. I had mine jimmy rigged with a jumper for the starter and left the two little ones alone. Car runs fine.

So just jump the fat wires and not worry about the rest ? Thanks

[silver350z05rb]

Sorry about wait, fat wire is starter,one is oil sensor,one is tranny,on the kouki the 2 top ones are starter and oil,the bottom by itself is the tranny one,so you can either cut off the kouki clip(very important to cut one wire at a time,rewire,then cut the next wire,this will allow you to not mix the wires up or forget which wire is which) and replace it with a zenki clip and re wire accordingly now that you know what the wires do, it should take about 5 mins or less,if you dont have a zenki style clip, just tap into the kouki lines and add wires and connect them directly to the chassis wires,also easy because you now know what each wire does,opening the lower harness completly will help you understand what each wire does,but not neeeded.

[Sideways_blksr20]

Thanks a lot man

[Sideways_blksr20]

I did the wiring and the starter click once now it wont even clik , i hear the fuel pump.

[silver350z05rb]

Try the power wire hooked up straight to the battery to see if its the starter even works,might be a bad starter

[Sideways_blksr20]

The starter was bad , car started:)
Now can u guys tell me what vcuums goes in here
http://i174.photobucket.com/albums/w97/cory_cnx/feb2cb46.jpg

Thankss

[silver350z05rb]

idk, just plug it into my butt.........i mean............ idk,never seen that,looks like some sort of CAlifornia bullshit emission

[Sideways_blksr20]

idk, just plug it into my butt.........i mean............ idk,never seen that,looks like some sort of CAlifornia bullshit emission

Lolllllllllll

[Sideways_blksr20]

can u guys tell me where does the brake booster goes connect it on the s14 ka ? Sorry guys this is my first ka swap , i,ve done pure rbs since i started in the 240 scene

[silver350z05rb]

if you havent found out yet, it goes somewhat behind the intake manifold near the passenger side, kinda towards the bottom, theres a nipple sitcking out

[eastslider]

hey so does this mean that the kouki dash plug and the zenki dash plug are the same pin outs? trying to do a zenki sr into zenki 240sx..

[Sideways_blksr20]

Yeah the same .

[eastslider]

Yeah the same .

thank you ur a life savior :) yay my sr is wired! :) i followed this guy

http://zilvia.net/f/tech-talk/209158-how-s14sr-into-s14-chassis.html