PDA

View Full Version : NJ Swain-coated SR20 Exhaust Manifold.....$150

jspaeth
11-10-2011, 07:49 PM
For sale is an SR20 exhaust manifold that is swain-coated.

The manifold was used for ~4000 miles after it was coated.....I recently put on ANOTHER manifold that had an external wastegate flange welded on, so I no longer needed this one.

Swain coating the manifold cost ~$250 + shipping each way.

The manifold has a broken stud, as can be seen in the photos.

However, this stud can be drilled out from the oppposite side and replace with a bolt, if you desire to do so.


Asking $150 + shipping from 08054 in NJ

http://i947.photobucket.com/albums/ad316/golfertilltheend/2011Sale/DSCN0798.jpg

http://i947.photobucket.com/albums/ad316/golfertilltheend/2011Sale/DSCN0799.jpg

http://i947.photobucket.com/albums/ad316/golfertilltheend/2011Sale/DSCN0800.jpg
jspaeth
11-11-2011, 09:12 AM
Bump!!!!!!!!!!
jspaeth
11-12-2011, 05:47 PM
bumpercars!
Jtuned_andy
11-12-2011, 08:39 PM
cant you just extract the stud without drilling? I would be interested to know. Would maybe come pick this up im located in philly
S13x88
11-12-2011, 09:13 PM
cant you just extract the stud without drilling? I would be interested to know. Would maybe come pick this up im located in philly

If there's enough thread, you could probably screw on two nuts onto the stud, then loosen the first nut that got put on. It might be able to extract it that way.
jspaeth
11-13-2011, 06:09 AM
cant you just extract the stud without drilling? I would be interested to know. Would maybe come pick this up im located in philly

If there's enough thread, you could probably screw on two nuts onto the stud, then loosen the first nut that got put on. It might be able to extract it that way.


The stud is snapped right above the joint, so most of the threads from the top half are gone :-/