PDA

View Full Version : 'tapping' into charge pipes


ezza
10-20-2011, 05:05 AM
I need to take a vac line from my intercooler hot pipe for my boost control solenoid.

what the best way to get a vac pipe friendly fitting installed? prefferably without welding.

would one of these be ok? would it make a good seal?

http://www.anver.com/images/components/fitting_pg/barbs/a1814b!.jpg
This is the smallest i can seem to find which is 6.4mm, but if im not mistaken the vac tubing for the solenoid is 3mm

any thought?

Propaganda
10-20-2011, 05:54 AM
I'd use something like THIS (http://www.frsport.com/index.php?target=products&mode=details&product_id=7854)

airman
10-20-2011, 08:23 AM
^Yes, that'd be the best bet. Most likely your hot pipe is at most 1/16" and that's just not enough room for threads. The BEST thing would be welding, however.

surfpac
10-20-2011, 08:31 AM
Like "Propaganga" said the cheapest best option, and clean looking.
http://www.frsport.com/index.php?target=products&mode=details&product_id=7854

+1 for Frsport too!

ezza
10-20-2011, 03:32 PM
I was thinking of using plumbing tape and a nut the other side of the pipe^

but yeah i think il use the fitting linked untill i get round to haveing my pipes welded (there are other bits i need adding/cutting out too)

thanks guys

slider2828
10-20-2011, 04:01 PM
This is what I did. I just tapped the pipe. screw in the fitting and then JBWeld around it.... done deal....

xdumbxguyx
10-21-2011, 01:28 AM
another solution if your using stock turbo is to tap the 3 bolt turbo outlet, therefore you can have enough threads.

idahotuner
10-21-2011, 10:37 PM
Yes I have done this a few times. Use JB weld not much on the fitting threads. Drill a hole about the same size as the nipple screw end. And put JB weld on it and thread it into your hot pipe the closer to the turbo the better response u will have