energy bushing differential install

[Options13]

i'm putting an s14 diff housing in my s13, so i ordered some bushing from frsport, *energy* and i'm just not getting the directions, but im assuming this is right? and i need a big washer at the top?

do i use a washer at the bottom too? because the bottom of the bushing is just chillin there, these a 2 piece bushings

http://i17.photobucket.com/albums/b90/timberlando/IMG_2008.jpg?t=1318735300

[huffandpuff00]

why not keep the s13 front of the diff and just switch the s14 rear case. stiffer, no bushing

Im assuming your doing an s14 subframe swap?

Zac

[Options13]

i bought the diff already installed in an s14 and don't wanna take it out to put in my s13 diff..

i have s13 rear subframe.

^^ in the above pictures? does that look right to you?

[huffandpuff00]

yeah its installed correct.
the fatter one goes on top and you do use the smaller ring on the bottom still.

[Options13]

do i run a washer both on top and bottom?

[huffandpuff00]

yup, the large one on top and small on bottom, but yes both are used

[Options13]

tytytytyt!

[rebornS14]

sorry to bring up an old thread. but the small ring spacer is attatched to the stock rubber bushing. how to i remove it to put on with the energy bushing? do i have to burn it off? same with the ones that go on the rear of the diff. the directions say to reuse the metal inner ring but they are also attatched to the stock rubber bushings.

so this is the piece i have to reuse with the engery suspension bushing kit but as you can see the rubber is stuck on the metal spacer. the instructions say nothing about burning it off or scraping it off. just saids to use it. anyone have experience with this?

http://i1.frsimg.com/images/detailed_images/Nissan_55474-65F00_01.jpg