Log in

View Full Version : rb25 intake manifold


shawty82
10-04-2011, 02:04 PM
soo i have an rb25 with a knockoff gredy manifold ( couldent tell you which one it is) but in the number two from the front injector hole where its cut to fit the injector bushing its cut too deep towards the top of the cut closest to the valve covers. anyway its causing a boost leak because the injector is not sitting at the right angle allowing air to pass though. does anyone have any clues of where i should turn next. liek a a lot of people i cant afford major costs im in college and barely hanging on to her. so i cant buy a new one. some mentioned that i could aluminum weld it then re drill to the right spec but i would like more suggstions before i go any further thanx peoples