Assembling the diff! Welded!

[hellaslows13]

So I pulled out my carrier out of my pumpkin and got my diff welded. I rushed the process of taking the diff apart and didn't get a chance to mark any of the parts. I need some reassurance that I did everything right.

Can someone review my photos and tell me if everything looks ok?

What i am worried about I'm not sure if i put the bearing caps on right. One of the sides is no sitting flush like the other side. (check 4th picture)

It's not going to kill me if I used a torque gun to torque down the bolts right? It's hard using a wrench because the diff moves around. The ring gear bolts I torque down with a gun and used red loctite. I didn't loctite the bearing cap bolts though.

I also had to press the carrier bearings with a block of wood and hammer.

Is there anything I need to make sure of before I throw the cap and fill up the diff? Anything I should be cautious of?

Thanks!

http://farm7.static.flickr.com/6158/6203133512_755688af6d_b.jpg
http://farm7.static.flickr.com/6151/6202621915_fe7abfbd83_b.jpg
http://farm7.static.flickr.com/6153/6203136184_613da68af0_b.jpg
http://farm7.static.flickr.com/6029/6203136936_7a4ca5ab7b_b.jpg
http://farm7.static.flickr.com/6167/6202621041_c7934363a8_b.jpg