rebuilt ka24de with trans l

[P-Funk alot]

ok i have a fresh rebuilt ka with trans has a light weight chromoly flywheel and exedy stage 2 clutch kit. rebuilt the motor to sell this car as a whole but now imma throw my rb in it. looking to get 750 obo for engine and trans godspeed radiator and harness. lemme know guys text me for fastest response 909-63-0910 the setup is located in san bernardino

[DreamN]

Details on rebuild? Who was it performed by? Receipts? Compression numbers?

[yeti303]

pm`d you, very intrested text me 949-680-9549

[kosmo91se]

interested, I'm sending a pm now

[P-Funk alot]

i performed the 2nd rebuild my self. all new stock parts were used. egr has been blocked of along with the butterflies in the intake mani. i have receipts for the gaskets and rings. the motor was previously rebuilt by someone the previous owner of the coupe i pulled it from payed someone to do it but who ever did it should have never touched the car luckily they gave up before damaging anything. he couldnt get it to run and sold it to me. i went through it and found very low compression across the board, did a leak down test and found that the rings were leaking by. i broke it down discovered that the rings were installed wrong and the 1 cylinder rings had collapsed due to water entering from a improperly installed intake mani. replaced the rings and re sealed it and replaced a bunch of bolts that were either to short, to long, or had been stripped out. the motor is tits now. i havent done a compression test cause i was going to install it into my coupe but plans have changed and i now have to install my rb in the car because i have a buyer for it. i used to do this for a living and have built and rebuilt many engines from stock to 400 hp rb25

[P-Funk alot]

sold lock it up. thanks yeti