jtmroczk
09-12-2011, 09:35 AM
http://i959.photobucket.com/albums/ae74/JustinMroczkowski/61672146.jpg
No part outs,
Weekend pick up only,
First come first serve,
skip to the bottom for videos,
build thread: Awesomely bad idea - VIPStyleCars.com (http://vipstylecars.com/forums/showthread.php?t=16312)
PM questions,
1994 infiniti Q45
stock vh45de with first gen 8-bit ecu(the one you can chip and reprogram)
2006 CD009 Z33 six-speed transmission, welded bell housing(fuck adapter plates)
Z32 resurfaced flywheel with Q45 ring gear for stock starter engagement
Z32 clutch, spec stage 3
Two piece drive shaft, two u-joints, stock center bearing, no rubber couplings.
Stock vlsd (well, grandma sure as shit didn't beat on it...)
Inside:
Sparco evo seat, red, rough condition, like had to add red duct tape condition
Sparco wheel 90mm dish great condition, always stored in doors
LTB motorsports spline type quick release
Sparco shift knob
Sparco 4" harness
A/C blows hot on high only, system holds presure a/c clutch doesn't engage. heat works.
Front power windows work, sun roof works but sticks
stock radio/tape works antenna wire cut
Dash, sheet metal(aluminium) door panels and two seats. all else is stripped
Outside:
K-sport coil-overs, listed 12kg/10kg but springs say 12.5k/11.5k? IIRC? (pair of helper springs and details for going lower included)
SPL RUCA (hybrid adjuster version, black)
SPL toe rods (hybrid adjuster version, chrome)
SPL outer tie rods(s13 shanks included)
Tein s14 inner tie-rods
shortened Megan tension rods
SPL sub-frame collars(solid bushings included, remind me, they're in the freezer)
ES steering rack bushings
ARP quick start front studs, good for 30mm slip-on spacers(rears included)
15mm hub-centric front spacers, aluminium hub-rings for mustang wheels included
Stainless brakes lines included
Front Hawk pads and new rotors included, current pads are good
front speed bleeders are on, rears are included
Wheels/tires:
Four(4) 5zigen FN01R-c 17x10 +12
mounted with Two(2) Kuhmo XS 245/45/17 at 25%
mounted with Two(2) Toyo T1R 275/40/17 at 20%(one is loosing air)
Two(2) 5zigen FN01R-c 17x10 +25(one has a wobble, since before i bought the pair, dozens of dead tires say its fine)
mounted with Two(2) Falken 912 235/50/17 at 80%
Four(4) bullshitass stock 15s with balding to slick tires
One(1) bin full of stuck stuff that didn't get tossed
One(1) medium size flat black helmet so you can drive it strait to an event.
The Good:
It’s a missile car. Starts easy, runs reliably, rips the shit out of tires and scares old people, kids and animals, open headers.
The Bad:
It’s a missile car. Leaks oil at the valve cover and rear main seal (replacements are included), pops out of 5th on deceleration, rips the shit out of tires and scares old people, kids and animals, open headers.
The Ugly:
Missile car, last fifth of the car is hamburger, open headers.
I don't have time for events or projects; it’s going to go, one way or another...
$4K obo
thanks,
Justin
Tampa, Florida
on-car and external matching runs:
Drifting Q45 CFRC 3-25-11 - YouTube (http://www.youtube.com/watch?v=_VpWkfmSScM&feature=related)
VpWkfmSScM
JN8lOYTsVeE
on-car and external matching runs:
Fx1zRf4sUTs
fD4QHIJfNDc
http://i959.photobucket.com/albums/ae74/JustinMroczkowski/345144d9.jpg
______
No part outs,
Weekend pick up only,
First come first serve,
skip to the bottom for videos,
build thread: Awesomely bad idea - VIPStyleCars.com (http://vipstylecars.com/forums/showthread.php?t=16312)
PM questions,
1994 infiniti Q45
stock vh45de with first gen 8-bit ecu(the one you can chip and reprogram)
2006 CD009 Z33 six-speed transmission, welded bell housing(fuck adapter plates)
Z32 resurfaced flywheel with Q45 ring gear for stock starter engagement
Z32 clutch, spec stage 3
Two piece drive shaft, two u-joints, stock center bearing, no rubber couplings.
Stock vlsd (well, grandma sure as shit didn't beat on it...)
Inside:
Sparco evo seat, red, rough condition, like had to add red duct tape condition
Sparco wheel 90mm dish great condition, always stored in doors
LTB motorsports spline type quick release
Sparco shift knob
Sparco 4" harness
A/C blows hot on high only, system holds presure a/c clutch doesn't engage. heat works.
Front power windows work, sun roof works but sticks
stock radio/tape works antenna wire cut
Dash, sheet metal(aluminium) door panels and two seats. all else is stripped
Outside:
K-sport coil-overs, listed 12kg/10kg but springs say 12.5k/11.5k? IIRC? (pair of helper springs and details for going lower included)
SPL RUCA (hybrid adjuster version, black)
SPL toe rods (hybrid adjuster version, chrome)
SPL outer tie rods(s13 shanks included)
Tein s14 inner tie-rods
shortened Megan tension rods
SPL sub-frame collars(solid bushings included, remind me, they're in the freezer)
ES steering rack bushings
ARP quick start front studs, good for 30mm slip-on spacers(rears included)
15mm hub-centric front spacers, aluminium hub-rings for mustang wheels included
Stainless brakes lines included
Front Hawk pads and new rotors included, current pads are good
front speed bleeders are on, rears are included
Wheels/tires:
Four(4) 5zigen FN01R-c 17x10 +12
mounted with Two(2) Kuhmo XS 245/45/17 at 25%
mounted with Two(2) Toyo T1R 275/40/17 at 20%(one is loosing air)
Two(2) 5zigen FN01R-c 17x10 +25(one has a wobble, since before i bought the pair, dozens of dead tires say its fine)
mounted with Two(2) Falken 912 235/50/17 at 80%
Four(4) bullshitass stock 15s with balding to slick tires
One(1) bin full of stuck stuff that didn't get tossed
One(1) medium size flat black helmet so you can drive it strait to an event.
The Good:
It’s a missile car. Starts easy, runs reliably, rips the shit out of tires and scares old people, kids and animals, open headers.
The Bad:
It’s a missile car. Leaks oil at the valve cover and rear main seal (replacements are included), pops out of 5th on deceleration, rips the shit out of tires and scares old people, kids and animals, open headers.
The Ugly:
Missile car, last fifth of the car is hamburger, open headers.
I don't have time for events or projects; it’s going to go, one way or another...
$4K obo
thanks,
Justin
Tampa, Florida
on-car and external matching runs:
Drifting Q45 CFRC 3-25-11 - YouTube (http://www.youtube.com/watch?v=_VpWkfmSScM&feature=related)
VpWkfmSScM
JN8lOYTsVeE
on-car and external matching runs:
Fx1zRf4sUTs
fD4QHIJfNDc
http://i959.photobucket.com/albums/ae74/JustinMroczkowski/345144d9.jpg
______