PDA

View Full Version : CA Rb25 86mm Cp pistons and Eagle rods


ariansworld
08-31-2011, 04:41 PM
Lmk if you're interested (951) 479-6414 Anthony

Selling my 86mm (standard size) Cp pistons with everything needed and eagle rods from my Rb25det. These are in very mint condition and have less then 100 miles on them do to spinning two bearings. I ordered two new Eagle rods since the other two that spun bearings warped, numbers 2 and 5 spun. The two that I ordered from Eagle rods, the guy asked me to weigh them so they can match the weight of the other four rods I have. So I took the four used rods I have to the post office where they weighed them. They were taken off and marked so that they would be installed the same way. $900 for everything. Thanks for looking.

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1262.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1263.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1261.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1260.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1258.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1264.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1259.jpg

The two new rods are on the far right.

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1265.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1266.jpg

http://i60.photobucket.com/albums/h13/aecqmc/DSCN1267.jpg

ariansworld
08-31-2011, 10:35 PM
Bump to the top!

spooled240
08-31-2011, 10:40 PM
bump for a homie, seen these in person they look brand new

let5l1de
08-31-2011, 11:07 PM
Come see me if you are interested in having this engine built once again.

glw the sell.

grp
~mario

AS240
09-01-2011, 08:03 PM
why did those bearings burn up? just curious

ariansworld
09-02-2011, 03:52 PM
why did those bearings burn up? just curious

The mechanic put the end caps wrong on the two rods that spun, I think and they were not properly lubed.

AS240
09-02-2011, 09:33 PM
damn that sucks. that's why i do all my own sh!t, i dont trust anybody else. plus i have OCD which comes in handy when building a motor.

ghudson
09-02-2011, 09:41 PM
The mechanic put the end caps wrong on the two rods that spun, I think and they were not properly lubed.
Hahaha good mechanic :picardfp:

ariansworld
09-08-2011, 07:56 PM
Hahaha good mechanic :picardfp:

Haha I know :/