tbirch
08-28-2011, 11:40 PM
Ive been looking all over online for how to efficiently bleed brakes with a hydraulic ebrake and I found what I thought was the right way to do it, but apparently its not or I messed up? what I did was loosen the nipple, Pull the E brake then started pumping the foot brake until there were no bubbles, then did the same on the driver side, then did the fronts as normal. but when I started the car to go for a test drive the foot brake was spongy all the way to the ground?
If anyone has a different process please let me know!
Thanks.
Here is my DIY e brake, made with a 92 prelude Clutch mast. cyl and scrap metal
http://i134.photobucket.com/albums/q94/tonybirch/IMAG0598.jpg
If anyone has a different process please let me know!
Thanks.
Here is my DIY e brake, made with a 92 prelude Clutch mast. cyl and scrap metal
http://i134.photobucket.com/albums/q94/tonybirch/IMAG0598.jpg