EGR from ka24e to ka24de

[stEEZE nikkAA]

Just put the DE in the car, but realized that the motor does not have any EGR components. I was thinking about putting the single cam EGR to the dual cam engine, but I am clueless as to where everything goes. Is it even possible to put the single cam EGR to the dual cam engine?

[ze12o]

why not just remove it? you really don't need it

[s14j]

^^^ yeah, just block it off.

[burns_rubber]

i have a ka24de wat block of plates do i need since they make a few for the car

ka24de block off | eBay (http://motors.shop.ebay.com/i.html?_from=R40&_trksid=m570.l2736&_nkw=ka24de+block+off)

[Wake]

Here you go buddy

*ISIS EGR Block Off Plate - Nissan 240sx 91-98 KA24DE [ IS-KA-EGR ] - Enjuku Racing - Performance Parts and High Quality Fabrication (http://www.enjukuracing.com/isis-block-plate-nissan-240sx-9198-ka24de-p-10803.html)

[stEEZE nikkAA]

K so I blocked off the EGR today. Basically closed up the hole in the exhaust manifold, then put a plate between the mounting surface of the EGR and the intake manifold. None of the control valves OR vacuum lines are on the car. Basically it is just the red circled part in this picture, along with the block off plate sandwiched between the intake manifold.

http://i37.photobucket.com/albums/e71/Lube716/egr00-1.jpg


None of the vacuum lines are there. Iirc, the vacuum lines connect to the charcoal canister... if so, do I just leave the charcoal canister nipples open and unplugged?