View Full Version : s13sr wont turn over
nujabe
08-21-2011, 05:04 PM
so heres the story.. my old s14 was totaled got another s14 shell swaped every thing over. every the electrically works in my car. my car trys to start just will not turn over. im getting fuel to the chambers. starter works. i have splitfire coil packs. and they worked great before infact there brandnew not even 2 weeks before the accident. i looked thorugh my harness every thing is grounded down from what i can tell. maf works. i have a power fc so im seeing my injectors work and i see how many rpm my starter is giving my car.
tuforteee
08-21-2011, 06:20 PM
i hope you're foreign?
nujabe
08-21-2011, 09:57 PM
Im doing this on my phone with swype... Not using the swype if you get what im saying. But maybe you might know. It sparks geta fuel and trys cranking but wont turn over :(
tuforteee
08-22-2011, 11:24 AM
so it cranks but wont start? see if you crossed fuel lines... i had the same problem, had spark and fuel (plugs were wet), but it wouldnt want to start... I ran them parallel to each other (thinking it was the correct way), but it turned out they had to cross at one point....
http://a7.sphotos.ak.fbcdn.net/hphotos-ak-ash4/292072_10150755036450032_746135031_20228868_543185 0_n.jpg
nujabe
08-22-2011, 01:34 PM
ill check. but i left the old fuel filter on so that it would not happen. it ran when i pulled it out of my old car =( why meee
tuforteee
08-22-2011, 03:28 PM
thats what i thought too, but i crossed the lines after the filter.... it gotta be fuel filter > injectors > fpr
GA378
08-24-2011, 12:37 PM
I remembering this happening to my s14 before...
nujabe
08-27-2011, 10:33 PM
ok its a fuel problem.. idk wtf it is thow. so let me start.. first thing i did was go buy some cold start and spray it in the intake manifold... but the rubber hose back over the intercooler piping and it fires up for a few seconds.. so its getting spark... and air. then i checked my gas in the car it was really bad so i drained it all out went and got good gas dumped it in.. still wont start. any ideas.. bad fpr or any thing please help !!!!
cotbu
08-28-2011, 01:53 AM
try this set engine at TDC, lift fuel rail, remove cas and unplug coil pack harness. place a towel or cardboard under fuel injectors. KOEO. Do you notice any leak? Spin cas gear. Do all of the injectors spray?
Answers
jvega
08-31-2011, 12:31 AM
maybe your flooding out the cylinders.
crank it with the injector clips disconnected, then connect them and try again?
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.