Injectors and resistors

[boost addict]

So I bought some sard 800cc low impedance top feed injectors for my sr and I'm just making sure which resistors to use. If I wire a 6.8ohm 10 watt resistor into the power wire will I be good. I searched but I'm not the best with electrical/wiring

[fliprayzin240sx]

Hope this helps...
http://zilvia.net/f/archive-faqs/133034-how-add-resistors-low-impedence-high-impedance-injectors-approved.html

[boost addict]

Just for future reference for people jwt sells the ones needed.

[surfpac]

I got a resistor box you can use. $30 shipped

[surfpac]

So I bought some sard 800cc low impedance top feed injectors for my sr and I'm just making sure which resistors to use. If I wire a 6.8ohm 10 watt resistor into the power wire will I be good. I searched but I'm not the best with electrical/wiring

You need to add 4 resistors (1 to each injector) if you want to go that route.
Or you can use a resistor box.

[Ekin_s13]

boost addict

i am doing the same thing that you are doing i have been doing a lot of search and i want to do a inline resistor as well. i have seen on Honda forum they use 6.8 ohm 10watt and on MegaSquirt they use 7.5 ohm 25 watt. they watt really matter? if you go on MegaSquirt web site they have a calculator on how much resistor you would need but it doesn't calculated how much watt i need to use. i am having a hard time understanding which is the right way of doing this. So which resistor did you use?

[boost addict]

call up jim wolf technologys, they talked me through it all. i think the guy was ben or sam??
they have the right resistors for this exact reason. i wanna say they were 6.8 ohm 10 watt

[Ekin_s13]

thanks good thing jim wolf technologys is in san diego i can just stop by their shop

[boost addict]

haha nice, lucky for you then