NO power to power fc

[nujabe]

so my power fc has no power.. the car will crank over when i put the key in and turn all my lights work.. every thing seems to be working except my power fc. i looked at all my ground also checked my fuses they all looked good so far is there any way i can test to see if i have a bad ecu or faulty wiring.. please help a brotha out before i go and just buy a new harness. the harness I'm using is not even 3 months old it was made at tech3 in san jose.. but to be honest i have my doubts about it.

thanks guys.

[s13 @ fullboost]

check the connection at the harness plug to the fc unit make sure it is tight and all the way in, sometimes the new units have a hard time mating with the old harness. put the key to on and your hand controller should light up and should have the apexi logo good luck i hope thats all it is.

[nujabe]

I tryed that . My fuel pump dont prime ether. ill go over it agin

[BNASTYs13]

you dont have a stock ecu you can try? sounds like you have it pretty much figured out. its either a bad ecu or bad harness. put your pfc on a friends car and see if it powers up. if it does then you know its a harness most likely

[nujabe]

well figured out the problem dash conection to the harness was not all the way in.. now i have another problem my fuel pump is not turning on.. im pluged in.. its a walbro 255.. any ideas ?

[Jake1992]

did you maybe check the fuel pump relay....

I have the same problem but i dont have an handheld.
My car turns on perfectly with oem ecu but not with
the power fc :werd: i opened it up ... nothing seems burned
no water damage.

any ideas?

[Sileighty_85]

ECCS Is wired wrong.

[Jake1992]

ECCS Is wired wrong.

any idea of where to start looking? :confused:

[Sileighty_85]

ECU plug or the plugs by the battery Tray

[Jake1992]

ECU plug or the plugs by the battery Tray

Thanks , so this morning ... i woke up read this message and it hit me... i had nothing to do so opened up the apexi , connect it to my car and started measuring the wires.. I noticed the relay wasnt getting ground. I checked in the kick panel and there was a relay loose ! so my car has one relay for turning on the OEM and one for the APEXI ... is that normal ?
wel anyways everyhing primes but car wont idle so it will shut off ... maybe wrong map ? or sensor ? dont have hand held either so maybe boost controller might be on there (which should be turned off) correct me if im wrong.

here is the site :S14 ECU Pinouts (http://www.200sx.org/s14-ecu.html)

hope it helps..