FS: NC: SR20DET Head

[JDS Performance]

FS: NC: SR20DET Head

[email protected]

Concord, NC 28025

$350.00

Pulled off a running SR20DET Blacktop for a build up and a race prepped head was used - valvetrain was torn down to install new valve oil seals that never happened - has been sitting in a box in my garage since

The blacktop valve cover was sold but I will include a redtop valve cover - has gasket but is misson 2 spark plug gaskets and well as the center smaller gasket

Everything is there minus the intake cam gear bolt & valve cover nuts/washers - Intake cam gear bolt is like $7 new - you can buy new valve kit on ebay for like $20 - all the bags were suppose to be labeled but I could not confirm this - I would suggest taking it to a machist getting it hot tanked, surfaced new valve oil seal installed and the valve train installed and shims/guides clearanced - this usally cost around $250.00 (parts included) - I can get this done for you if needed

http://i82.photobucket.com/albums/j274/joshds25/SDC13193.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13194.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13195.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13196.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13197.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13198.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13199.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13201.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13202.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13203.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13204.jpg
http://i82.photobucket.com/albums/j274/joshds25/SDC13205.jpg