No break lights!! doesn't turn on

[240sx-pat]

Hey, Guys I've been having an issue with no break lights since I did my SR swap and never really bother with it until about 2 days ago. I've read through a couple of threads about no break light issue and a lot seem to have been caused by the break switch at the pedal so I thought I went a head and replace that ,but it's not fixed now I'm lost.


So here's the situation I have the kouki Tailights and wired them up correctly , the hazard light works my left and right turn signal works and my actual tail light works when I turn the nob at the steering wheel. However I do not get that bright break light to come on when I step on the break pedal , before I thought about replacing the switch I unpluged the old one and tried to jump the red/yel and the green/red wire to see if it would light up, but it didn't I had a muti meter and the damn thing died before I could get any kind of readings on it.

both 15A fuse on the driver side are good , I just don't know wtf is going on or where to track this wiring , does it go through the radio part of the car by any chance? I got an FSM but I'm not very good with these , but I'm trying til then does any one here have any experience with this one??

[Wake]

DUDE seriously? B-R-A-K-E.

Im not helping you until you learn to spell.

*BTW have you tried checking the bulbs?

[240sx-pat]

DUDE seriously? B-R-A-K-E.

Im not helping you until you learn to spell.

*BTW have you tried checking the bulbs?



Alright brake , and yea I checked it.. it appears to be okay nothing burnt up or anything I checked the ground at the hatch also, and it was good.

[Wake]

if one of the filaments is burned out, the bulb itself wont be burned just the little filament wont be connected

[240sx-pat]

if one of the filaments is burned out, the bulb itself wont be burned just the little filament wont be connected

I went back out to check just to make sure and all the bulbs appear to be okay on all 4 of them , but who knows I'mma go get some new battery for my mutimeter and see if I get anything on the brake light portion of the harness back at the hatch.

and yea all the filaments were intact

Anything else on your mind let me know

[PeekayzS13]

Check fuse, or relay.