PDA

View Full Version : problems with isis z32.

ScRote20det
07-08-2011, 02:58 PM
just got an isis z32 maf and put it on my sr20det. im pretty sure ive got the wires correct....my car barely idles...my safc2 doesnt seem to be making any difference when i try and tune it... i deff need some help. i put my settings at in-2 out-6 and tryed all others and that seemed to alow it to idle the best.
4-20sx
07-08-2011, 03:02 PM
lol. get ur ecu tuned for the maf

safc doesnt do much but fine tune if you get ur ecu tuned by enthalphy or jwt
vas570sx
07-08-2011, 03:10 PM
yeah dude, not sure if you can tune for a different maf with an safc. I have an Enthalpy tune and its golden.
rob_213
07-08-2011, 03:32 PM
not sure if this is your problem, but I was barely getting any reading from my isis maf, I had to go buy an oem z32 maf. I read elsewhere that people had similar problems...
ScRote20det
07-08-2011, 04:28 PM
not sure if this is your problem, but I was barely getting any reading from my isis maf, I had to go buy an oem z32 maf. I read elsewhere that people had similar problems...

did it run fine with an oem z32
4-20sx
07-08-2011, 04:32 PM
yea ide rather buy oem MAF. you can easily pick up one at pick a part for cheap!
DoobieS13
07-08-2011, 04:36 PM
anything electronic from isis is JUNK.get a oem one
rob_213
07-08-2011, 04:38 PM
did it run fine with an oem z32

Yes i picked one up used for 40 bucks and it worked perfectly
soreballz
07-08-2011, 05:02 PM
"Problems with Isis..." Stop right there. That's your problem.
rob_213
07-08-2011, 05:13 PM
"Problems with Isis..." Stop right there. That's your problem.

idk some isis products seem to be good quality and a cheaper alternative, but they need some time to work on their electronics. Enjukuracing wouldnt sell garbage and when I asked about the problem they were more than happy to fix it
nismoracingsx
07-08-2011, 05:18 PM
i only wish i could find a z32 maf at my junk yard -.- some assclown keeps yanking practically every maf in every car of interest...killin me -.0
had to settle for an n60..
ScRote20det
07-08-2011, 07:57 PM
so if i get an enthalpy....will the isis maf work fine? or would it be wearth the hastle of sending the isis back and waiting on an oem to get here... and then get enthalpy?
rob_213
07-08-2011, 09:19 PM
so if i get an enthalpy....will the isis maf work fine? or would it be wearth the hastle of sending the isis back and waiting on an oem to get here... and then get enthalpy?

theres really no telling.. unless you check the amount of volts your reading.. i would go oem just to be safe