PDA

View Full Version : No crank after installing LS1 coils???


260sexways
07-04-2011, 02:35 PM
Cranking issue fixed but still have no spark, i'm running aem series 2 on a ka-t. NGK iridium plugs and stock plug wires.Just trying to getit to start then i'll move on to the upgrades.Everything is wired from ka-t's how to and settings are the same except for the dwell which i had the wizard do.Can anyone back me up on what the setup is supposed to be...
http://www.ka-t.org/forums/viewtopic.php?t=26234
Here's my setup
http://i699.photobucket.com/albums/vv358/blake110491/Capture3.png
http://i699.photobucket.com/albums/vv358/blake110491/Capture4.png

sean350z
07-05-2011, 09:37 PM
Arent there different dwell settings for those coils...might want to look into that for your ecu.

sean350z
07-05-2011, 09:40 PM
Google is your friend....took me two seconds to find this

www.ka-t.org :: View topic - How to run LS1 Coils (http://www.ka-t.org/forums/viewtopic.php?t=26234)

260sexways
07-06-2011, 02:48 AM
Ya there's multiple settings, everything is tuned right. Pretty sure its my damn starter, i'll test it tomorrow. tedious to take the thing off...
Thanks though

260sexways
07-07-2011, 02:15 AM
Alright tested the starter which of course was good.I finally got the motor to crank, for some reason it took ten min for it to turn over consistently but its all good now.I just installed the LS1 coils which wasn't to bad and for some reason i'm not getting spark. I looked at the aem diagram to make sure i pinned everything correctly and i'm just using the stock plug wires if that matters. can't get the damn car started if anyone could help that'd be awesome, thanks.

260sexways
07-07-2011, 02:45 PM
BUMP anyone??? I need this car running ASAP

slow92
07-08-2011, 10:58 PM
you need to check your settings. I did this upgrade on my SR with a haltec and I had to change the dwell settings and one other setting and the car started on the first try. So if your settings are good then it is probably your wiring. You need to retrace all of the things that you did in order to install these. Start simple, especially if the car started fine before installing the coils. I ended up becoming a member of the haltec's forum, I would look into that for aem or something of the sort.