Anybody running the N1 Dual and ST sways on their 97-98???

[Black 97SE]

I have ST-sways and I just installed the Apexi N1 dual, but the fit is so tight. I had a blitz nur spec R, but it was too loud for me. It took forever for me to put the exhaust on myself, because the rear sway bar seemed to get in the way of the exhaust. If anybody else has this setup, can you explain how you fixed this problem.

Sidenote: My clutch pedal is sticky. Sometimes when I release it, it gets stuck a little, then pops back up about a second later.

I like this new exhaust a lot =). So quiet.

[Black 97SE]

Oh, I'm thinking of selling the Blitz Nur Spec R exhaust too. I bought it for $560. It's only been used for just over a month.

[CoasTek240]

wow, so i never heard of any sort of installation probs with any of the s14a's that ive seen install that exhaust (quite a few)

but might i ask, where did you buy your apex n-1 dual?

[Sanchi]

Its a pain putting in the the N1 duels regardness of the sway. It is very tight back there. Even with out the ST sway bar. I was dum enough to put my exhause on b4 my sway bar :doh:

[Black 97SE]

Umm, I ordered my exhaust from www.enjukuracing.com. Atm they have a 499.99 special =). Yeah, it's a major pain installing that exhaust hehe. My blitz was easy, but this exhaust+ST sways was so hard. The sway bar still gets in the way a little. Anybody with this problem care to explain how you fixed it?

[kanekz]

I installed my Dual N1's myslef too. It wasnt too bad but yea, an extra pair of hands could've helped.
As far as your sticky clutch pedal...seems like you need to readjust it. This should help you

Clutch pedal adjust (http://www.store.yahoo.com/phase2motorsports/howtoadclpe.html)

[95Blue240sx]

i dont have the ST swaybars, but i do have the whiteline ones. i got my dual n1s on with not much trouble. the first time i tried to fit it in it hit the swaybar, but once i got another hand helping it was much easier. shouldnt be too hard.