PDA

View Full Version : s14 sr harness question


dynogod1995
04-16-2011, 12:20 PM
hey guys im swapping a 98 s14sr in my 95 s14. my question is what needs to be done to the sr harness. ive been told it just needs extended is this true? thanks for your help.

Hoffman5982
04-16-2011, 02:58 PM
Extend the o2 sensor and MAF plugs and repinning the dash plug. Also cut the wiper motor plug off and resolder in the one from the KA harness. The wire colors between the two wiper motor plugs are the same, just the plug itself is different

dynogod1995
04-16-2011, 07:03 PM
sweet thanks man how much does the o2 and maf plug have to be extended.

Hoffman5982
04-16-2011, 10:15 PM
No problem, and it really depends on how you route it. The o2 sensor really only needs a few inches longer, and I extended my MAF about 2-3 feet and ran it through my fender to keep it hidden. I also ended my CAS and injector plugs to tuck them away better

dynogod1995
04-17-2011, 09:05 AM
k as far as the repin on the dash plug how hard is that ive never done it.

Hoffman5982
04-17-2011, 11:43 AM
It's time consuming. You have to take a little needle and unpin each wire one by one. As far as which wires you are supposed to change around there aren't a lot of complete conversion diagrams on the net for the s14 sr

dynogod1995
04-17-2011, 08:03 PM
im sure if i do it pin by pin i can figure it out.