FS: Datsun 510 SR20DE (SoCal)

[Topher88]

Body is very strait but attention is needed for the fenders. Car has a rack 200SX rack and pinion steering with shortened tie rods. Motor cross member was flipped and truck motor mounts installed for SR motors. Right now the engine is pulled but can easily be installed if you want. Car needs a trans cross member and a drive shaft. Car comes with all glass but no windshield. has all seats, dash and most trim. i have a few fenders and tail lights you can choose from. a little rust in rear passenger quarter panel, trunk and drivers side floor. i have all the side markers and wires from stock set up along with the upper wire harness for the DE. Car is selling as is with SR20DE engine Asking $3000 OBO I am located in Redlands. Hit me up at (909) 528 4453 http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2432.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2436.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2426.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2425.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2262.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2261.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2461.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2493.jpg
http://i22.photobucket.com/albums/b327/calguywithferrari/IMG_2494.jpg

[Topher88]

bumpy i really need this thing gone

[Topher88]

commmeee oonnnn

[calikidder]

hmmmm 1000??

[calikidder]

how much just for the shell?

[IiS14iI]

bump, someone restore this back to life

[Topher88]

the car is sold Sold