PDA

View Full Version : loose clutch pedal after SR20 swap Need help!!!


240sx-pat
04-09-2011, 08:37 AM
I am just about finished with this swap but I've ran into an issue I just hooked up the clutch line to the clutch slave cylinder and went I went to check the pedal there was no pressure on it at all. When I step on the pedal it goes straight to the floor with zero pressure and I gotta pick it back up with my feet. Do you guys have any idea what the hell is going on here?

Sileighty_85
04-09-2011, 08:40 AM
there is air in the line, bleed the air out

240CoupeLuke
04-09-2011, 12:29 PM
hey i have the same problem ..except i have a ORC clutch and mine goes right to the floor..as i blees it out, the slave gets pushed out too far and blows fluid everywhere..it seems as if my clutch fork needs adjustment..like its to far out and isnt touching the pressure plate soon enough...i need help to guys.

240sx-pat
04-09-2011, 05:35 PM
Thanks to Sileighty I was about to fix it , I don't know much about cars so when mine would go straight to the floor I was panicking like WTF was going on, anyways I had a friend pump the clutch while I was checking the bleeder. Mine did the same at first and shit just spew everywhere when I was doing it alone that why I got him to help. I had to keep my eye on the clutch fluid level and kept refilled it then gave him the go a head to pump the clutch. Now the clutch is tight and feels great man.

fliprayzin240sx
04-09-2011, 08:14 PM
hey i have the same problem ..except i have a ORC clutch and mine goes right to the floor..as i blees it out, the slave gets pushed out too far and blows fluid everywhere..it seems as if my clutch fork needs adjustment..like its to far out and isnt touching the pressure plate soon enough...i need help to guys.

You got the wrong TOB or carrier...slave cylinder is basically over extending itself.