View Full Version : apex-i rev speed meter rsm
manos1984
09-30-2003, 02:12 PM
I have an apexi rev speed meter with the g-sensor. it works great but i need to sell.
I would like to get $200 shipped for it.
possible trades for car audio
any questions or offers email me at
[email protected]
thanks mark
s13andy
09-30-2003, 04:57 PM
iv got a 780 watt pioneer amp and a 10in 800 watt sub in a q logic box all stuff in new condition, not used for hard hitting stuff just to add a little extra bass to music, but it hits...hard
let me know
manos1984
09-30-2003, 06:41 PM
Is that 780 watts rms or max and is it a 2 channel or mono and what is the sub. do you have any pictures and some more specs on the amp and sub.
thanks
mark
s13andy
09-30-2003, 07:31 PM
ok well i dont know a whole lot about it, it is 2 chan. i dont have any pictures rightnow but i kan get some soon, and i belive it is a legacy sub im not sure right now. i paid over 200 for the amp alone and it is in brand new condition, and i have all the wires you would need as well.
s13andy
09-30-2003, 07:35 PM
ok i just pulled it out, its 760 watt max power, the model number is gm-x962, on the side it says its a 2 ch bridgeable. the sub is a legacy saphire 800 watt, it is red and black. i remember there are numbers and stuff on the back but i didnt take it out of the box, and the bow is a brand new Q logic box, im told those are VERY nice quality boxs
s13andy
09-30-2003, 07:46 PM
heres a picture of what the amp looks likehttp://www.mobilcaraudio.com/i/amplifiers/GM-X962_big.jpg
and some fetures: Features
PWM Regulated MOSFET Power Supply
Bridgeable 1/2/3 Channel Capability
Balanced Isolator Input Circuit
Oversized Screw-Type Power/Ground Terminals
Screw-Type Speaker Terminals
RCA Inputs
Hi-Volt Input Level Control (200mV-6.5V)
Selectable Crossover: 80Hz, -12dB/oct. (LPF)
Specifications
Continuous Power (14.4V): 125Wx2 (4 ohm), 190Wx2 (2 ohm), 380Wx1 (4 ohm)
Max Power (14.4V): 250Wx2 (4 ohm), 760Wx1 (4 ohm)
Frequency Response: 10Hz - 50kHz (0,-1dB)
Total Harmonic Distortion: 0.008% (1kHz, 4W)
Signal-to-Noise Ratio: 100dB (IHF-A)
Dimensions: 11" x 2-5/16" x 12-3/4"
Delivering 760 Watts (peak) of power, the GM-X962 is a fearsome weapon in the war against wimpy music. This 2-channel amplifier features Pioneer's PWM regulated MOSFET power supply that is highly efficient, yet stunningly ferocious. The oversized screw-type power/ground terminals and screw-type speaker terminals allow you to use larger-gauge speaker wire. Bigger wire, more current flow, better sound. And, a built-in selectable crossover makes the install easier and faster. Now, even short trips to the store will be memorable. Hey, is that the last of the milk?
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.