PDA

View Full Version : Car wont stay running !!!!!!!!!!!


Eramo323
03-16-2011, 06:04 PM
Found out that it was throwin codes
11 + Crank angle sensor circuit
34 Detonation sensor circuit
then i went and changed my distributor following the tutorial set it at top dead center and pointing rotor at #1 cylinder still no luck it'll crank but wont start....... so i tried setting the timing again two more times after that still no luck evn after i used some jumper cables to get more juice from the battery still nada........ changed spark plugs, spark plug wires, the distributor came off a running s13 cleaned my IACV im pretty sure im getting gas becasue i disconnected the line after the fuel filter and turned the ignition to ACC and fuel squirted out, im getting some spark too i disconnected every wire while cranking and grounded it im getting blue spark, uhmm i don't know what else to look for after that i checked the ECU for more codes and im getting 55 everything is OK!>!<?>?< o_0 HELP ANYBODY

CRANKS HARD BUT WONT START

ArBy25DeT
03-17-2011, 03:42 PM
replace those sensors??

Eramo323
03-18-2011, 05:40 PM
BUMP i kno theres an answer out there lol somebody help me get my s13 back on the road

timinthehood
03-18-2011, 06:07 PM
maybe your maf?

Eramo323
03-18-2011, 06:22 PM
i disconnected my MAF and tried turning on my car just canks the same and wont start up

Eramo323
03-19-2011, 01:37 PM
bumpity bump bump

LB 180SX
04-02-2011, 04:25 PM
i had a similar problem.. car would turn off after turning the key.. when i held the key in the on it will start up, but as soon as i released, egine would turn off.. had to replace then ignition and cables.. and baam!! just some input

Eramo323
04-04-2011, 09:04 PM
Thanks for the help but I found out the stupid crank angle sensor.wasnt even working so I got some other distributor and shit runs now