Slotting Rear Upper arms

[datsundime]

I dunno if anyone has tried slotting your stock rear upper arms to correct the negative camber. Well I did try it and it was fine for a couple of days, however the wieght of the vehicle just pushed the bolt and the upper arm in the original position. Has anyone come up with a solution for this? I think I'm just gonna have to use a MIG welder to fill in the gap. Any ideas?

[ka24detkyle]

Weld a washer on the outer edge of the slot. The bolt will still fit.
give me your email addy and i'll send you a pic.

[Andrew Bohan]

you've done that? the weld holds up to the weight of car okay?

[ka24detkyle]

Not one bit of problem!!!!

have fun

[datsundime]

Thanx for the tip. I'll be sure to try it this weekend.