View Full Version : Tomei expreme SR manifold, turbo outlet elbow crealance issues
The High & Mighty
02-20-2011, 01:56 AM
okay so i installed a tomei manifold on my redtop SR with a T28 earlier today, but i noticed the turbo outlet elbow has clearance issues with the transmission bell housing. similar to the picture below. any suggestions on what elbow setups will bolt up properly. before i go out and buy a tomei expreme elbow
very similar to what my clearance issue (i found this picture on a thread with unanswered questions)
http://i263.photobucket.com/albums/ii131/RG-S13/IMG_6199.jpg
nismoman
02-20-2011, 07:45 AM
Get the tomei
LoneStarSilvia
02-20-2011, 07:56 AM
Back when my I owned a S14 I had the Tomei manifold also, but I had an aftermarket turbo outlet and it fit without an issue.
BlitzRPS13
02-20-2011, 11:02 AM
Yea why even bother with the stock turbo outlet? Buy the tomei one.. it'll fit.
Ninjamasta04
02-20-2011, 11:17 AM
Tomei manifold will actually push the turbo slightly back towards the firewall. A stock or ebay turbo outlet will not clear the bell housing. Therefore, you will have to get a Tomei outlet.
mikeroy420
02-20-2011, 11:27 AM
Does the Greddy Turbo Elbow clear the bellhousing with the Tomei Expreme and the gt2871?
The High & Mighty
02-20-2011, 11:33 AM
Thanks for all the inputs. I'll post up pics when i get my hands on a tomei outlet and installed. I was getting ready wrap up yesterday when i noticed the stock t28 outlet elbow didn't quite fit.
thanks again for all the inputs.
dopplganger1
02-20-2011, 11:34 AM
do you have the clocking plates for the t28? that could be your problem
The High & Mighty
02-20-2011, 11:36 AM
to Mikeroy420.
i was looking at this thread last night and it seems that the greddy or the pbm wont clear the transmission
S13 SR Tomei Expreme manifold and PBM Cobra : SR20DET Forum (rear-drive) (http://forums.nicoclub.com/s13-sr-tomei-expreme-manifold-and-pbm-cobra-t502371.html)
to dopplganger1 : are you talking about those DIF clocking plates?
dopplganger1
02-20-2011, 11:41 AM
yes i am, was just thinking they could angle it differently but not sure after looking at that thread
The High & Mighty
02-20-2011, 11:48 AM
those only re clock the position of the intake compressor inlet and the outlet for the hot pipe.
uperformance
02-20-2011, 12:00 PM
i run tomei manifold.
on a t25 flanged 3071. greddy outlet has like 4 mm between the tranny. i was also looking into a new elbow now, or a new manifold. :/
The High & Mighty
02-22-2011, 07:47 PM
I bought the tomei elbow today and installed it. fit like a glove. There's about 6mm between the elbow pipe and the transmission bell housing. I'll take some pics sometime this week.
BiG MiKE86
02-24-2011, 05:15 PM
I have the same manifold with GT2871r and Circuit Sports DP - fitment is perfect - could it be that your turbo needs to be clocked a bit? Shouldnt have to buy their elbow to use the manifold
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.