Building a driveshaft questions

[Tiny_T]

where are you guys buying your yokes and end yokes for building one piece driveshafts?

[singlecamslam]

uh usually you just take them off your old 2 piece shit, take it to the driveshaft place, and they cut the ends off and make a one piece.

[Tiny_T]

uh thats honky. see Im going to make my own, and I know people have gotten yokes and end yokes that you can use replaceable u joints with. I just dont know where to get them

[Sileighty_85]

Hope you plan on balancing it

[chiboy002]

maybe drive shaft shop?

[HPKMotorsports3]

contact national oil seals or timken maybe they might be able to help you source out a yoke

[Tiny_T]

Hope you plan on balancing it

why would i do that? my car makes 36whp and all i do is slide at low speeds. get real

ill give those two places a call, good idea

[Couped_up'd]

I only seen poeple use there only ends. =(

[singlecamslam]

The driveshaft places can renew your yokes. I think that might be your best bet, or i'm not sure.

[Tiny_T]

The driveshaft places can renew your yokes. I think that might be your best bet, or i'm not sure.

OK. so. I have an s13 driveshaft. which means I have that stupid rubber bullshit on the front yoke. I could get an s14 driveshaft and cut it apart and make a one piece driveshaft, but thats lame. I dont want a driveshaft with un changeable u joints.

that is why I am searching for fresh yokes and end yokes so I can make a nice driveshaft because thats what I do, I make stuff. I dont need to spend 300 some dollars for a driveshaft shop piece when Im probably gonna break a few of these anyways.

[spent27]

Driveshaft Specialist Inc (http://www.driveshaftspecialist.com/)

They made me a driveshaft for my VQ swap... Both yokes have removeable/replaceable ujoints... They were very helpfull, would definitely recommend.

[Sileighty_85]

OK. so. I have an s13 driveshaft. which means I have that stupid rubber bullshit on the front yoke. I could get an s14 driveshaft and cut it apart and make a one piece driveshaft, but thats lame. I dont want a driveshaft with un changeable u joints.


Find an SR20 DS they dont have that gay bushing on them

[Flicktitty]

check these guy's out. i was actually looking for a local place to build a aluminum D/s for my next project.

A-1 Drive Shaft - Driveshafts * Front Wheel Drive Axles * Rack & Pinions (http://a1driveshaft.com/index.html)