S1 RB25DET stock parts for sale - Need Space (and some Xmas cash!)

[MitchP]

I need space (and some Xmas cash!) so these items have to go. Some of this stuff has been sitting around (inside) for years, literally. If you are looking for something in particular, I may have it, just ask, there's a bunch of random smaller parts I have that are not listed/pictured. I am not gonna post prices and no reasonable offers will be refused. Willing to accept offers for everything listed/in photos at pretty good deal if it's reasonable. Willing to sell parts separated - such as TB from intake or injectors from rail - or all together.

Here's a list:
-Used Q45 TB with TPS and TPS connector pigtail
-Low Mileage stock push type clutch setup - PP, Disk & FW + an extra FW
-Greddy intake manifold to stock TB adapter
-S1 Coils - full set of 6, all work
-S1 igniter - the small one, works
-Coil cover
-Stock Engine harness including injector harness but minus coil harness - OK shape, some of the split loom is missing on MAF and BCS leads
-Stock boost control solenoid
-S1 Hitachi CAS
-Stock intake manifold including TB, side feed injectors, rail, regulator, IAC's, coolant temp sensors and coolant tube.
-Another stock intake manifold upper and lower half with gasket for in between
-Another set of stock injectors
-Another stock fuel rail (missing some of the screws and injector hold downs)
-Another stock fuel pressure regulator
-Stock Exhaust Manifold (not cracked w/ heatshield and no broken turbo studs, one heatshield bolt broken off in it though)
-Stock Turbo with O2 housing, compressor outlet elbow and heat shield - (took off running engine, spins really nice and no broken studs - 6psig WG spring)
-Stock turbo water and oil lines with the banjo bolts
-Qty. 2 stock turbo inlet rubber tubes with the metal BOV tube
-Stock BOV
-Qty. 2 stock charge pipes (the one that attaches to the TB)
-Charge pipes from Greddy S13 SR20 FMIC kit (3 pipes)
-Used timing belt in good shape - off of running engine
-Various pulleys, brakets, belts including crank pulley/damper.
-CAS mount
-Engine/Trans separator plate.
-Lower tranny to engine block supports

Eh... that's it unless I find more stuff.

Located in SoCal - Carson Area. Zip is 90248. Willing to ship, buyer pays. Local pickup OK.

Thanks for looking!

[Flushed_S14]

Do you still have the Exhaust manifold bolts?

[MitchP]

Yes, I still have some exhaust manifold to head studs, fatty washers and lock nuts. I don't think I have a full set but if you're looking to replace a few broken ones (I know they tend to break, and hence why I don't have full set) I think I can help you out. Lemmy dig'em up and see how many I actual have and will let you know.

[Nimso]

Do you have the A/C bracket bolts?

[babowc]

I'll take ps/ac bracket, manifold tb adapter and few exhaust studs if you got em.. Lmk with price in pm! Thanks

[babowc]

And the charge pipes too...

[nyc240sx]

pmed u for the rb separator plate