PDA

View Full Version : NY FS: NY S13 SR20DET Blacktop part-out!!!


s13pimp
12-08-2010, 04:13 PM
Well, I was running MSD 72lb injectors on my sr and one of them failed, causing a lean condition in cylinder 2, which damaged the water jacket in cyl two. For all intensive purposes, the block is not salvageable. However, everything else is in great working order. Everything is for sale except for the CAS. I have everything else including:

-Stock T25 (in EXCELLENT condition) *SOLD*
-Valve cover (small dent from leaving a tool on it and closing the hood) *SOLD*
-3 coilpacks (one of the 4 is badly cracked) $25 (each)
-Coilpack harness $30
-2 knock sensors *SOLD*
-O2 sensor *SOLD*
-MAFS $35
-coolant temp sensor $10
-Wiring harness (not the greatest I've seen) *SOLD*
-Lower trans harness $50
-2 sets of stock cams $40 (each)
-Stock exhaust manifold $25
-T25 with blown seals [I think] $40
-alternator $30
-2 sets of stock fuel injectors, rails and FPR's $115 (each)
-ARP head studs (used for about 1000 miles, probably less) $75
-Transmission *SOLD*
-water pump*SOLD*
-oil pan $20
-timing chain tensioner $30
-Head (Looks excellent, but might need machining) $150
-bottom end (pistons and other components are in *GOOD* condition) (make an offer)
-Fidanza flywheel *SOLD*
-ACT 6 puck unsprung clutch (good condition) $140
-Stainless steel turbo lines (t25, t28) $60
-Passenger side door w/ mirror and door card (s13, primered black, crank windows) $65 (picked up)
-Electric driver side mirror $20
-Stance GR+ Pro springs (2 8kg front, 2 6kg rear) $50

I'm getting tired of listing things, so if you need something, just ask. I most likely have it since I have a complete swap basically. Ask for pictures if you want them. Email is the best way to get in touch. [email protected]

All prices are OBO

l2edken
12-08-2010, 05:10 PM
stock downpipe available?

s13pimp
12-08-2010, 05:30 PM
No, but the stock turbo elbo is. You wouldn't happen to have meant that, would you?

90hatchie
12-09-2010, 01:44 AM
where in ny are you im lookin to pick up that turbo :-)

240boost
12-09-2010, 08:56 AM
flywheel picture? and where in ny.

s13pimp
12-09-2010, 10:53 AM
For all that asked, I'm located in Syracuse, NY.

Pics of flywheel:

http://i227.photobucket.com/albums/dd132/s13pimp/1128101854.jpg

http://i227.photobucket.com/albums/dd132/s13pimp/1128101856.jpg

The friction plate is a little rusty. It could be resurfaced, or you could simply order a new friction plate for $61, and then you would have a brand new flywheel.

s13pimp
12-12-2010, 10:26 AM
Bumb to the top!

s13pimp
12-16-2010, 03:42 PM
Bump! All prices are OBO!

negrosx13
12-16-2010, 04:54 PM
Where is your location iin ny??..I want the alternator

s13pimp
12-16-2010, 05:40 PM
I'm located in Syracuse (unfortunately).

s13pimp
12-17-2010, 06:15 PM
Bump! Added ss turbo lines!

hkspwrsr
12-17-2010, 06:40 PM
do you have an intake suction hose? filter to turbo

s13pimp
12-20-2010, 06:04 PM
do you have an intake suction hose? filter to turbo

Sorry, It's not for sale. Good luck finding one!

s13pimp
12-22-2010, 04:00 PM
Bump! Reduced prices and revised list!

sr20sean
12-22-2010, 04:51 PM
got any pics of that clutch?

s13pimp
12-25-2010, 08:42 AM
got any pics of that clutch?
I sure do! I can post some pics in a little bit. Also, I'll be in New Paltz next weekend so pickup is possible if you decide you want it.

two40guy
12-25-2010, 09:29 AM
you wouldnt happen to have an aluminum radiator for sale would you?

Razi
12-26-2010, 03:40 PM
Do the manifolds have the stock heatsheild?

s13pimp
12-26-2010, 04:37 PM
Sorry for the delay, but here is a picture of the clutch.
http://i227.photobucket.com/albums/dd132/s13pimp/1128101852-1.jpg

And sorry, but I have no radiator for sale.

I have only one manifold left, and I actually dont think it has a heat shield. I can check tomorrow though.

Prez
12-26-2010, 05:28 PM
where is dent on valve cover? picture?


and would you be interested in selling just the compressor wheel off that t25... otherwise cause i know you dont wanna fuck with that snap ring.... make that t25 $30 shipped to DE 19713 and you got a deal....
and depending on location of the "dent" i might take valve cover too.

Tempnix
12-26-2010, 07:03 PM
Sent PM. :D

Prez
12-26-2010, 07:05 PM
Thanks For Valve Cover!

somedude
12-27-2010, 09:11 PM
how much for the mafs shipped to 84015

409-ef8
12-27-2010, 09:21 PM
Ps pump and bracket shipped to 77662

s13pimp
12-27-2010, 09:32 PM
Sorry, but I sold the PS pump and bracket.

The maf will be $53 shipped to your door!

409-ef8
12-27-2010, 09:42 PM
damn lol there like gold

somedude
12-28-2010, 07:27 AM
The maf will be $53 shipped to your door!


ok cool pm'd you

s13pimp
12-28-2010, 03:43 PM
Just sent you a pm back! :D

s13pimp
12-28-2010, 05:12 PM
damn lol there like gold

Haha yeah, I know! I wish you got to me like two days sooner because I ended up selling the whole setup to my buddy at "bro pricing" (which basically means I gave it to him for free hahaha).

s13pimp
12-29-2010, 03:49 PM
Bump. Updated list.

s13pimp
01-03-2011, 04:53 PM
Bump! All prices OBO

levelgx
01-03-2011, 05:14 PM
do you have a powersteering tensioner?

s13pimp
01-06-2011, 12:07 PM
Sorry, I sold the tensioner already. Good luck finding one! :)

s13pimp
01-11-2011, 01:35 PM
To the top!

s13pimp
01-22-2011, 12:46 PM
To the top again! :D

racerx2k1
01-23-2011, 09:31 AM
Bumb to the top!

Bump! All prices are OBO!

Bump! Added ss turbo lines!

Bump! Reduced prices and revised list!

Just sent you a pm back! :D

Bump. Updated list.

Bump! All prices OBO

To the top!

To the top again! :D

2 bump limit. You can start new thread in 3 days.