Johny5
10-04-2010, 07:03 AM
This is a fully checked over sr20det motorset ready to drop right into your car. Whats included:
-motor itself
-sr20 transmission
-sr20 wiring harness already wired for an s13
-sr20 ignitor
-sr20 ecu
-stainless braided oil and coolant lines routed to water neck like s14 sr20s
-aftermarket oil pan
-act 6puck clutch/exedy stage 2 pressure plate/new throwout bearing
-aluminum intake pipe with sr20 maf and aftermarket intake filter
-aluminum underdrive pulley set (alternator pulley included but not installed)
-megan racing exhaust manifold and turbo elbow
-original great condition sr20 ac compressor included but not pictured
-intake manifold/throttle body/IACV/injectors ARE included and in great condition but not shown in pics
-i went through the motor and cleaned up everything i saw wrong with it, all coolant lines have been replaced that needed it. turbo coolant lines were adressed and redone properly. manifold nuts have proper lock tabs and turbo elbow has been converted to full stud setup and tack welded so that it will never give you problems.
basically this motor is a PERFECT example of a drop-in ready to go motorset. if you buy from an importer you will have to check over and replace or upgrade most of the parts i have and then-some. i have done all the hard work for you just take this motor and drop it right in. motor starts very quickly and sounds terrific.
http://img.photobucket.com/albums/v338/kidnrg/new%20batch/SDC10502.jpg
http://img.photobucket.com/albums/v338/kidnrg/new%20batch/SDC10504.jpg
http://img.photobucket.com/albums/v338/kidnrg/new%20batch/SDC10505.jpg
aim: johny5notarobot
email: [email protected]
-motor itself
-sr20 transmission
-sr20 wiring harness already wired for an s13
-sr20 ignitor
-sr20 ecu
-stainless braided oil and coolant lines routed to water neck like s14 sr20s
-aftermarket oil pan
-act 6puck clutch/exedy stage 2 pressure plate/new throwout bearing
-aluminum intake pipe with sr20 maf and aftermarket intake filter
-aluminum underdrive pulley set (alternator pulley included but not installed)
-megan racing exhaust manifold and turbo elbow
-original great condition sr20 ac compressor included but not pictured
-intake manifold/throttle body/IACV/injectors ARE included and in great condition but not shown in pics
-i went through the motor and cleaned up everything i saw wrong with it, all coolant lines have been replaced that needed it. turbo coolant lines were adressed and redone properly. manifold nuts have proper lock tabs and turbo elbow has been converted to full stud setup and tack welded so that it will never give you problems.
basically this motor is a PERFECT example of a drop-in ready to go motorset. if you buy from an importer you will have to check over and replace or upgrade most of the parts i have and then-some. i have done all the hard work for you just take this motor and drop it right in. motor starts very quickly and sounds terrific.
http://img.photobucket.com/albums/v338/kidnrg/new%20batch/SDC10502.jpg
http://img.photobucket.com/albums/v338/kidnrg/new%20batch/SDC10504.jpg
http://img.photobucket.com/albums/v338/kidnrg/new%20batch/SDC10505.jpg
aim: johny5notarobot
email: [email protected]