91 cams F/S

[drifties151]

i have a set of cams from a 91 240sx, i just picked them up today, nothing wrong with them. they come with cam sprockets too. i do not have a pic, there is no abrasions on any surfaces. engine had 124,xxx miles on it. for those of you who do not know, the 91 cams are considered better than the others due to a more aggressive design giving you more power up top, if you were to swap these into you 91-98 dohc motor. yes they do fit s14's. with dohc ka engine. im asking $80 shipped obo. im located in northern NJ, flat rate is around $8-$10 for these. thanks alot. reach me on here or through email: [email protected]
-terry

[drifties151]

pic of the cams

[SaintlyCharBoy]

do you have any of the necessary shims? or any info about the swap?

[ryan hagen]

well i start out by offering $50, i just had pdm cams put in mine but i m building a second motor, shimming them is fun, its about $8 to $10 a shim and expect to change alot of them, i had a valve job done after my pdm cams and had to get 8 made for the exhaust side.trial and error or finding the right thickness to determine the shim is about the only info on this swap i know of. its better to have the shims loose than tight so you dont burn the valves and seats. and yah not reshiming or checking your clearences could be bad.....

[drifties151]

ryan hagen check your PM