1994 RX7 bridge ported, 450+whp

[project06tj]

Year: 1994
Make: Mazda
Model: RX-7
Price: $9,000 or TRADE
Mileage: 124,000 on body, 15,000 on motor, 5,000 on turbo
Color: Primer

I've decided to sell my baby. I've owned this car since May of this year, when I purchased it off of a forum member, and I won't give out his name, but he was not completely truthful about the vehicle. It is in the condition it is now due to him; I have never hit anything with it, never drifted it, I doubt I've even put 1,000 miles on it.

Heres a little background on it:
Purchased the car in May from just outside Harrisburg, PA.

Drove it home, and not even 5 miles from home the motor failed. Snapped E-shaft.

Found a cheap replacement motor, 28,000 original miles, swapped it in with a new transmission, and not even 500 miles later that motor failed as well. Coolant seal.

Just recently I purchased a used motor and turbo setup from a member of the rx7club.

I have completed the swap, but there are some underlying issues with the car as it sits, and I just don't have the patience, the want, the money, or the time to do anything with it.

Quick spec list:
BDC Half-Bridge Port 13B REW
Mild Exhaust Ports
2mm OEM mazda apex seals
HD Pineapple Racing Water Seals
All brand new seals
Brand new housings w/ low mileage rotors
New rotor bearings
Gotham Oil Pan Brace
Polyurethane Engine Mounts
Fully Balanced Rotating Assembly by Mazdatrix
Spec Stage 3 6puck clutch with SR motorsports 9lb flywheel
Runs Evans waterless coolant
A-Spec Borg Warner S362 Turbo Kit
Divided T4 Manifold
Tial 44mm Wastegate with 1bar spring
Borg Warner S362 T4 w/ divided .82 a/r exhaust
3" downpipe to 3" mandrel bent piping all the way to 3" Apexi GT spec (catless, although I can include a cat, and plenty of other spare parts with the sale)
Greddy elbow, knock off Greddy type RS
Brand new Pettit Coolcharge III SMIC intercooler (not even one mile on it)
HKS Twin Power
Walbro 255
Apexi PFC, Commander (Gotham holder) and Datalogit
B&M Short shifter
Fludyne Radiator
New fuel filter ( less than 1,000 miles)
Tein coilovers (basics)


I have well over $7,000 in the engine and turbo setup alone.

The good:
It runs, and drives. Engine sounds good, and when I got it tuned I was told it was a very healthy motor.
Previous owner made around 450WHP at 1bar (I never got the chance to dyno it)
Perfect project car, that could save you thousands in the long run (my loss is your gain)
This is a very fair price for what you are getting, it makes me sick to think of the money I will be losing selling the car at this price.
Clean title


Issues:
Oil pan appears to be leaking, very minuscule leak if one at all, car sat for two weeks and the dipstick still reads full.
Needs alignment (I dropped the PPF to get to the oil pan to reseal it, and obviously the reseal failed)
Needs a good tune (it doesn't idle well)
There is some ignition break up above 6500 RPM; its got me stumped.
I believe one of the U-joints has gone bad in the driveshaft.

None of these are a HUGE issue, I'm just tired of working on this car, and I've ran out of funding.


Body:
Its in pretty rough shape. The previous owner really did a number on her. Passengers side quarter panel is pretty rough. I do have a replacement panel and inner rocker I will include with the sale. At a reputable local body shop i was quoted $4400 for all of the body work and a full paint job.


Pictures (taken today)
http://i182.photobucket.com/albums/x305/gibrian92/101_0806.jpg
http://i182.photobucket.com/albums/x305/gibrian92/101_0807.jpg
http://i182.photobucket.com/albums/x305/gibrian92/101_0815.jpg
(My camera is not the best)

http://i182.photobucket.com/albums/x305/gibrian92/IMGP1334.jpg

http://i182.photobucket.com/albums/x305/gibrian92/IMGP1331.jpg

http://i182.photobucket.com/albums/x305/gibrian92/IMGP1322.jpg

more pics:


Pictures by gibrian92 - Photobucket (http://s182.photobucket.com/albums/x305/gibrian92/)

walk around:
rx.mp4 video by gibrian92 - Photobucket (http://s182.photobucket.com/albums/x305/gibrian92/?action=view&current=rx.mp4)


I need this car gone before I leave for the airforce, so make me an offer. I am very open to trades, as long as the car needs nothing, not new tires, not new brakes, nothing. Car must be able to be daily driven AS-IS!

I am willing to give someone a VERY good deal if they have something to trade.

[project06tj]

I'd be interested in trading this car for a mildly drift ready 240. I picked up a daily driver, and this car is just sitting at my neighbors property taking up space. I believe the oil leak is fixed, as there is not a drop of oil underneath the car, and its been sitting for over a week now. Just took it for a short drive today, ran great, and no oil leaks.

make me an offer!

[seanforney]

Hey man since you got a dd. I have a 1998 328is turbo. Needs a tune up and a tune that's it. Let me know if your interested. Thanks.

[seanforney]

Shoot me a text 3019881147. Thanks.

[Garber]

ah i remember this car. it was on craigslist for like a year and then i saw the thread where you said it blew up on the way home. glad to see you got it back on the road again!

[blueshark123]

trade for a 03 4x4 ford escape fully loaded

[ROOSEY]

glws man. btw i havent seen the motor untill now in the pic and holy turbo!! looks way cleaner then it did with the other motors.

[ranger240]

glws....

what car is the steering wheel off? a newer fd?

just curious... hopefully the buyer gets this car back into shape

[project06tj]

glws man. btw i havent seen the motor untill now in the pic and holy turbo!! looks way cleaner then it did with the other motors.

hahah, you should hear it whistle at about 1 psi. Sounds like an airplane is taking off from my hood. Then when the open wastegate dump opens up it makes people stare. It is extremely loud.

I've decided to take another direction with the car, I'm going to be parting out the motor as a whole, thanks for the offers everyone, but I'm going to have to decline.

edit: steering wheel is off a newer miata.

[yoozef]

http://zilvia.net/f/cars-sale/341797-1998-240sx-se-113k-miles-4500-a.html
let me know

[tibbyluv]

Year: 1994
Make: Mazda
Model: RX-7
Price: $9,000 or TRADE
Mileage: 124,000 on body, 15,000 on motor, 5,000 on turbo
Color: Primer

I've decided to sell my baby. I've owned this car since May of this year, when I purchased it off of a forum member, and I won't give out his name, but he was not completely truthful about the vehicle. It is in the condition it is now due to him; I have never hit anything with it, never drifted it, I doubt I've even put 1,000 miles on it.

Heres a little background on it:
Purchased the car in May from just outside Harrisburg, PA.

Drove it home, and not even 5 miles from home the motor failed. Snapped E-shaft.

Found a cheap replacement motor, 28,000 original miles, swapped it in with a new transmission, and not even 500 miles later that motor failed as well. Coolant seal.

Just recently I purchased a used motor and turbo setup from a member of the rx7club.

I have completed the swap, but there are some underlying issues with the car as it sits, and I just don't have the patience, the want, the money, or the time to do anything with it.

Quick spec list:
BDC Half-Bridge Port 13B REW
Mild Exhaust Ports
2mm OEM mazda apex seals
HD Pineapple Racing Water Seals
All brand new seals
Brand new housings w/ low mileage rotors
New rotor bearings
Gotham Oil Pan Brace
Polyurethane Engine Mounts
Fully Balanced Rotating Assembly by Mazdatrix
Spec Stage 3 6puck clutch with SR motorsports 9lb flywheel
Runs Evans waterless coolant
A-Spec Borg Warner S362 Turbo Kit
Divided T4 Manifold
Tial 44mm Wastegate with 1bar spring
Borg Warner S362 T4 w/ divided .82 a/r exhaust
3" downpipe to 3" mandrel bent piping all the way to 3" Apexi GT spec (catless, although I can include a cat, and plenty of other spare parts with the sale)
Greddy elbow, knock off Greddy type RS
Brand new Pettit Coolcharge III SMIC intercooler (not even one mile on it)
HKS Twin Power
Walbro 255
Apexi PFC, Commander (Gotham holder) and Datalogit
B&M Short shifter
Fludyne Radiator
New fuel filter ( less than 1,000 miles)
Tein coilovers (basics)


I have well over $7,000 in the engine and turbo setup alone.

The good:
It runs, and drives. Engine sounds good, and when I got it tuned I was told it was a very healthy motor.
Previous owner made around 450WHP at 1bar (I never got the chance to dyno it)
Perfect project car, that could save you thousands in the long run (my loss is your gain)
This is a very fair price for what you are getting, it makes me sick to think of the money I will be losing selling the car at this price.
Clean title


Issues:
Oil pan appears to be leaking, very minuscule leak if one at all, car sat for two weeks and the dipstick still reads full.
Needs alignment (I dropped the PPF to get to the oil pan to reseal it, and obviously the reseal failed)
Needs a good tune (it doesn't idle well)
There is some ignition break up above 6500 RPM; its got me stumped.
I believe one of the U-joints has gone bad in the driveshaft.

None of these are a HUGE issue, I'm just tired of working on this car, and I've ran out of funding.


Body:
Its in pretty rough shape. The previous owner really did a number on her. Passengers side quarter panel is pretty rough. I do have a replacement panel and inner rocker I will include with the sale. At a reputable local body shop i was quoted $4400 for all of the body work and a full paint job.


Pictures (taken today)
http://i182.photobucket.com/albums/x305/gibrian92/101_0806.jpg
http://i182.photobucket.com/albums/x305/gibrian92/101_0807.jpg
http://i182.photobucket.com/albums/x305/gibrian92/101_0815.jpg
(My camera is not the best)

http://i182.photobucket.com/albums/x305/gibrian92/IMGP1334.jpg

http://i182.photobucket.com/albums/x305/gibrian92/IMGP1331.jpg

http://i182.photobucket.com/albums/x305/gibrian92/IMGP1322.jpg

more pics:


Pictures by gibrian92 - Photobucket (http://s182.photobucket.com/albums/x305/gibrian92/)

walk around:
rx.mp4 video by gibrian92 - Photobucket (http://s182.photobucket.com/albums/x305/gibrian92/?action=view&current=rx.mp4)


I need this car gone before I leave for the airforce, so make me an offer. I am very open to trades, as long as the car needs nothing, not new tires, not new brakes, nothing. Car must be able to be daily driven AS-IS!

I am willing to give someone a VERY good deal if they have something to trade.

http://zilvia.net/f/cars-sale/347498-testing-waters-1990-rx-7-clean.html

http://zilvia.net/f/cars-sale/347059-1990-gtu-fc-sale-82-000-orig-miles-testing-waterstitle-hand.html

[1991ls13]

, am i missing something?
looks like a whore thats been in the business way to long. GL with 9k, hell even 7k.

[AllShowNoGo28]

, am i missing something?
looks like a whore thats been in the business way to long. GL with 9k, hell even 7k.

lol recheck your prices dude.... 9k is a fucking steal for this. fd shells sell for 4-7k alone. and his motor is worth bank. a blown 13b shortblock sells for 1000 alone. this is an absolute steal coming from another fd owner

[jonnyrx7]

You'd make way more money parting this out on rx7club.com

[C-unit]

this is zilvia dude..no one will buy a rx7 over 5g..lol

i am having a hard time selling mine as well..

[driftrkp]

93 240 coupe rb25 swap coilovers all links 5 lug wide body silvia front let me know it your interested

[joe645733]

lol recheck your prices dude.... 9k is a fucking steal for this. fd shells sell for 4-7k alone. and his motor is worth bank. a blown 13b shortblock sells for 1000 alone. this is an absolute steal coming from another fd owner
i think the price is pretty fair.
but the way you're talking about his car is crazy. the shell looks like a beater. a paint job alone will cost you a few thousand.

[aps13]

You should consider taking payments cuz I would do anything to have this car, I'd offer you my 240sx with rb20 but it has bad injectors..

[aps13]

????????????